FAN-7002-R datasheet(14/66 Pages) ARISTA

14 / 66 page

When mounting the switch in a partially filled rack, load the rack from bottom to top, with the

heaviest equipment at the bottom. Load the switch at the bottom if it is the only item in the rack.

The accessory kit provides mounting brackets for four-post racks. Contact your sales representative

to obtain two-post mounting racks.

•

Power Requirements: Power requirements vary by switch. Refer to Table 1: 7300 Modular Switch

and Component Specifications for information regarding your specific system.

Multiple circuits provide redundancy protection. The switch uses power cables that have an

IEC-320 C19 plug. The accessory kit provides IEC-320 C19 to C20 power cables.

Important: All power input plug-socket combinations must be accessible at all times; they

provide the primary method of disconnecting power from the system.

Toutes les combinaisons de fiche-prise d’entrée de puissance doivent être accessibles en

tout temps; ils fournissent le principal moyen de coupure d’alimentation du système.

•

Other Requirements: Select a site where liquids or objects cannot fall onto the equipment and

foreign objects are not drawn into the ventilation holes. Verify these guidelines are met:

•

Clearance areas to the front and rear panels allow for unrestricted cabling.

•

All front and rear panel indicators can be easily read.

•

AC power cords can reach from the AC power outlet to the connectors on the front panel.

Important: Disconnecting power to all input sockets is required to completely power off

the unit.

Coupure d’alimentation sur toutes les entrées il faut pouvoir complètement l’appareil hors

tension.

2.2

Tools Required for Installation

Each switch provides an accessory kit that contains parts for installing the switch into a four-post rack.

Two-post rack mount parts are available through your sales representative.

Accessory kits do not include screws, nuts, or bolts for attaching the switch to a conventional rack.

In addition to the accessory kit, the following tools are required to install a modular switch:

All Racks

Mechanical device capable of lifting chassis being installed (chassis weight listed in Table 1: 7300

Modular Switch and Component Specifications ).

Two-Post Conventional Rack

•

Screws or rack mounting nuts and bolts.

•

Screwdriver.

Four-Post Tool-less Rack

No additional equipment required.

Four-Post Conventional Rack

•

Screws or rack mounting nuts and bolts.

•

Screwdriver.

FAN-7002-R 数据表(PDF) 14 Page - Arista Networks, Inc

FAN-7002-R 数据表(HTML) 14 Page - Arista Networks, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

数据表下载