FAN-7002-R datasheet(17/66 Pages) ARISTA

17 / 66 page

Chapter

Rack Mounting the Switch

Important: The rack mounting procedure is identical for all modular switches. Illustrations in

this chapter depict the mounting of an unpopulated DCS-7304 chassis.

Les procédure de montage du bâti est identique pour tous les commutateurs modulaires.

Illustrations dans ce chapitre montrent le montage d’un châssis de DCS-7304 inhabité.

•

Two-Post Rack Mount provides instructions for mounting the switch in a two-post rack.

•

Four-Post Rack Mount provides instructions for mounting the switch in a four-post rack.

After completing the instructions for your rack type, proceed to Powering the Modular Switch .

3.1

Two-Post Rack Mount

To mount the switch to a two-post rack, assemble mounting brackets to the middle of the chassis, then

attach the brackets to the rack.

Important: Two-post rack mount parts are only available through your sales representative.

Two-post rack mounting is not supported for DCS-7316 switches.

Pièces de montage rack à deux montants sont uniquement disponibles par l’intermédiaire de

votre représentant des ventes. Montage en rack de deux-poteau n’est pas supporté pour les

commutateurs DCS-7316.

The accessory kit includes the following two-post mounting parts:

•

2 center-mount brackets.

•

16 (DCS-7304) or 20 (DCS-7308) M4x8 panhead Phillips screws.

3.1.1

Attaching Mounting Brackets to the Chassis

1. Orient the switch chassis and the two center-mount brackets (Figure 2: Attaching the Center-mount

Brackets).

Figure 2: Attaching the Center-mount Brackets

Position the flanges that attach to the rack posts toward the front of the chassis.

FAN-7002-R 数据表(PDF) 17 Page - Arista Networks, Inc