PPC405GPR-3JB400 datasheet(44/57 Pages) AMCC

44 / 57 page

405GPr – Power PC 405GPr Embedded Processor

AMCC

Revision 2.04 – September 7, 2007

Data Sheet

Spread Spectrum Clocking

Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405GPr. This controller

uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to

as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the

SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the

PPC405GPr the following conditions must be met:

• The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the

PPC405GPr with one or more internal clocks at their maximum supported frequency, the SSCG can only lower

the frequency.

• The maximum frequency deviation cannot exceed

−3%, and the modulation frequency cannot exceed 40kHz.

In some cases, on-board PPC405GPr peripherals impose more stringent requirements (see Note 1).

• Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock tracks

the modulation.

• Use the SDRAM MemClkOut since it also tracks the modulation.

Notes:

1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of

approximately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the

connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaffected

by the modulation.

2. Operation of the PPC405GPr PCI Bridge is unaffected by the use of a SSCG.

For PCI frequencies of 33.33 MHz and below the PCI controller supports synchronous mode operation. This is

accomplished by strapping the PPC405GPr for synchronous mode PCI and connecting the PCI bus clock to the

PPC405GPr SysClk input. For 33.33 MHz signalling, the PCI specification has no limitation on the amount of

frequency deviation or modulation that may be applied to the PCI clock. Therefore, the PPC405GPr SSCG

requirements stated above take precedence.

At PCI frequencies above 33.33 MHz, the PCI controller must be operated in asynchronous mode. When in

asynchronous mode, the PCI bus clock must be driven into the PPC405GPr PCIClk input. In this configuration

the PCI controller supports the 66.66 MHz PCI clock specification which specifies a maximum frequency

deviation of -1% at a modulation of between 30 kHz and 33 kHz.

3. Ethernet operation is unaffected.

4. IIC operation is unaffected.

Caution: It is up to the system designer to ensure that any SSCG used with the PPC405GPr meets the above

requirements and does not adversely affect other aspects of the system.

PPC405GPR-3JB400 数据表(PDF) 44 Page - Applied Micro Circuits Corporation

PPC405GPR-3JB400 数据表(HTML) 44 Page - Applied Micro Circuits Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

数据表下载