| 数据搜索系统,热门电子元器件搜索 |
|
HYS64T64020HDL 数据表(PDF) 13 Page - Qimonda AG |
|
|
|||||||||||||||||||||||||||||
HYS64T64020HDL 数据表(HTML) 13 Page - Qimonda AG |
|
13 / 70 page ![]() Internet Data Sheet Rev. 1.1, 2006-10 13 03292006-5LTN-QML0 HYS64T[32/64/128]xxxHDL-[25F/2.5/3/3S/3.7/5]-B SO-DIMM DDR2 SDRAM Module 3 Electrical Characteristics This chapter lists the electrical characteristics. 3.1 Absolute Maximum Ratings Caution is needed not to exceed absolute maximum ratings of the DRAM device listed in Table 8 at any time. TABLE 8 Absolute Maximum Ratings Attention: Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. TABLE 9 DRAM Component Operating Temperature Range Symbol Parameter Rating Unit Note Min. Max. V DD Voltage on V DD pin relative to VSS –1.0 +2.3 V 1) 1) When V DD and VDDQ and VDDL are less than 500 mV; VREF may be equal to or less than 300 mV. V DDQ Voltage on V DDQ pin relative to VSS –0.5 +2.3 V 1)2) V DDL Voltage on V DDL pin relative to VSS –0.5 +2.3 V 1)2) V IN, VOUT Voltage on any pin relative to V SS –0.5 +2.3 V 1) T STG Storage Temperature –55 +100 °C 1)2) 2) Storage Temperature is the case surface temperature on the center/top side of the DRAM. Symbol Parameter Rating Unit Note Min. Max. T OPER Operating Temperature 0 95 °C 1)2)3)4) 1) Operating Temperature is the case surface temperature on the center / top side of the DRAM. 2) The operating temperature range are the temperatures where all DRAM specification will be supported. During operation, the DRAM case temperature must be maintained between 0 - 95 °C under all other specification parameters. 3) Above 85 °C the Auto-Refresh command interval has to be reduced to t REFI= 3.9 µs 4) When operating this product in the 85 °C to 95 °C TCASE temperature range, the High Temperature Self Refresh has to be enabled by setting EMR(2) bit A7 to “1”. When the High Temperature Self Refresh is enabled there is an increase of I DD6 by approximately 50% |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |