E5CS-X

E5CS-X

12

Precautions

Mounting

All Temperature Controllers in the E5CS-X Series conform to

DIN43700 standard.

The recommended panel thickness is 1 to 4 mm.

Flush Mounting

Insert the Temperature Controller, back end first, into the hole of the

mounting panel. Mount the adapter by pushing it forward from the

back of the Temperature Controller. Push the adapter as close as

possible to the front panel of the Temperature Controller to eliminate

the gap between them. Then, secure the adapter with screws as

shown in the figure below.

Removal

Loosen the screws on the adapter and push the hook open to re-

move the adapter.

Hook

Screw

Environment

Do not install the Temperature Controller in locations subject to dust

or corrosive gases. Do not install the Temperature Controller in loca-

tions subject to heavy vibrations or shocks, splashes of water or oil,

or high temperatures.

Separate the Temperature Controller from equipment that gener-

ates strong, high-frequency noise such as high-frequency welders.

Connection Examples

Solderless Terminal

Use M3.5 solderless terminals with the Temperature Controller’s

M3.5 self-rising pressure plate screws.

Solder-dipped Lead Wires

Strip the lead wire 6 to 12 mm and carefully arrange the wire tip.

Do not tighten the terminal screw with excessive force.

Input Sensor Connection

The lead wires connecting the sensor to the Temperature Controller

must be separated from power lines and load lines wherever pos-

sible, to prevent them from being induced by noise.

Use the specified compensating conductors for the thermocouple

type Temperature Controllers.

Use lead wires with a small resistance for the Platinum resistance

thermometer type Temperature Controllers.

Sequence Circuit

Several seconds are required until the relay is turned ON after pow-

er is supplied to the Temperature Controller. Therefore, take this

time lag into consideration when designing a sequence circuit which

incorporates the Temperature Controller.

OMRON Corporation

Industrial Automation Company

Measuring and Supervisory Controls Division

28th Fl., Crystal Tower Bldg.,

1-2-27, Shiromi, Chuo-ku,

Osaka 540-6028 Japan

Tel: (81)6-6949-6035/Fax: (81)6-6949-606

ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.

To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.

Cat. No. H032-E1-2A In the interest of product improvement, specifications are subject to change without notice.

Printed in Japan

0300-0.3M (0689)

a