WM8741 datasheet(21/63 Pages) WOLFSON

21 / 63 page

Product Preview

WM8741

PP Rev 1.3 October 2007

Figure 11 Initial Setup of Two WM8741 Devices into Control Interface Daisy Chain Mode

To write to a single device in the chain a complete sequence needs to be written to all the devices.

Devices that do not require a register change must also be written to. The user can choose to write

either the same data as the previous write, or write all 1s for the register address and data. All 1s will

result in writing to a non-existent register, address 7Fh, preserving the current register settings.

Figure 12 shows an example of how to access three WM8741 devices (the devices have all

previously been configured in daisy chain mode):

Figure 12 Daisy Chain Control Interface Example for Three WM8741 Devices

To ensure that only valid data is written to the devices in daisy chain mode, a pull up resistor is used

in SDOUT. When connected to the SDIN pin of the next device in the chain, this results in all ones

being written to the control interface of that device until the correct daisy chain data is written and

latched.

Serial daisy chaining is available only when using 3-wire serial control mode. It is not available in 2-

wire serial control mode or hardware control mode.

BIT

LABEL

DEFAULT

DESCRIPTION

Mode Control 2

08h

SDOUT

3 wire Serial Interface Daisy

Chaining

0 = No Output

1 = Output on pin 25.

Table 9 Control Interface Daisy Chaining Selection

WM8741 数据表(PDF) 21 Page - Wolfson Microelectronics plc