USB3290 datasheet(23/46 Pages) SMSC

23 / 46 page

Small Footprint Hi-Speed USB 2.0 Device PHY with UTMI Interface

Datasheet

SMSC USB3290

Revision 1.5 (11-02-07)

DATASHEET

The behavior of the Transmit State Machine is described below.

Asserting a RESET forces the transmit state machine into the Reset state which negates

TXREADY. When RESET is negated the transmit state machine will enter a wait state.

The SIE asserts TXVALID to begin a transmission.

After the SIE asserts TXVALID it can assume that the transmission has started when it detects

TXREADY has been asserted.

The SIE must assume that the USB3290 has consumed a data byte if TXREADY and TXVALID

are asserted on the rising edge of CLKOUT.

The SIE must have valid packet information (PID) asserted on the DATA bus coincident with the

assertion of TXVALID.

TXREADY is sampled by the SIE on the rising edge of CLKOUT.

The SIE negates TXVALID to complete a packet. Once negated, the transmit logic will never

reassert TXREADY until after the EOP has been generated. (TXREADY will not re-assert until

TXVALD asserts again.

The USB3290 is ready to transmit another packet immediately, however the SIE must conform to

the minimum inter-packet delays identified in the USB 2.0 specification.

7.5

RX Logic

This block receives serial data from the CRC block and processes it to be transferred to the SIE on

the DATA bus. The processing involved includes NRZI decoding, bit unstuffing, and serial to parallel

conversion. Upon valid assertion of the proper RX control lines by the RX State Machine, the RX Logic

block will provide bytes to the DATA bus as shown in the figures below. The behavior of the Receive

State Machine is described below.

The assertion of RESET will force the Receive State Machine into the Reset state. The Reset state

deasserts RXACTIVE and RXVALID. When the RESET signal is deasserted the Receive State

Machine enters the RX Wait state and starts looking for a SYNC pattern on the USB. When a SYNC

pattern is detected the state machine will enter the Strip SYNC state and assert RXACTIVE. The length

of the received Hi-Speed SYNC pattern varies and can be up to 32 bits long or as short as 12 bits

long when at the end of five hubs. As a result, the state machine may remain in the Strip SYNC state

for several byte times before capturing the first byte of data and entering the RX Data state.

After valid serial data is received, the state machine enters the RX Data state, where the data is loaded

into the RX Holding Register on the rising edge of CLKOUT and RXVALID is asserted. The SIE must

clock the data off the DATA bus on the next rising edge of CLKOUT. If OPMODE = Normal, then

stuffed bits are stripped from the data stream. Each time 8 stuffed bits are accumulated the state

machine will enter the RX Data Wait state, negating RXVALID thus skipping a byte time.

Figure 7.4 Receive Timing for Data with Unstuffed Bits

USB3290 数据表(PDF) 23 Page - SMSC Corporation

USB3290 数据表(HTML) 23 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

数据表下载