USB3290 datasheet(35/46 Pages) SMSC

35 / 46 page

Small Footprint Hi-Speed USB 2.0 Device PHY with UTMI Interface

Datasheet

SMSC USB3290

Revision 1.5 (11-02-07)

DATASHEET

Figure 8.5 HS Detection Handshake Timing Behavior (HS Mode)

Table 8.7 Reset Timing Values

TIMING

PARAMETER

DESCRIPTION

VALUE

HS Handshake begins. DP pull-up enabled, HS

terminations disabled.

0 (reference)

Device asserts Chirp K on the bus.

T0 < T1 < HS Reset T0 + 6.0ms

Device removes Chirp K from the bus. 1 ms

minimum width.

T0 + 1.0ms < T2 <

HS Reset T0 + 7.0ms

Downstream facing port asserts Chirp K on the

bus.

T2 < T3 < T2+100µs

Downstream facing port toggles Chirp K to Chirp J

on the bus.

T3 + 40µs < T4 < T3 + 60µs

Downstream facing port toggles Chirp J to Chirp K

on the bus.

T4 + 40µs < T5 < T4 + 60µs

Device detects downstream port chirp.

Chirp detected by the device. Device removes DP

pull-up and asserts HS terminations, reverts to HS

default state and waits for end of reset.

T6 < T7 < T6 + 500µs

Terminate host port Chirp K-J sequence (Repeating

T4 and T5)

T9 - 500µs < T8 < T9 - 100µs

The earliest time at which host port may end reset.

The latest time, at which the device may remove

the DP pull-up and assert the HS terminations,

reverts to HS default state.

HS Reset T0 + 10ms

USB3290 数据表(PDF) 35 Page - SMSC Corporation

USB3290 数据表(HTML) 35 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

数据表下载