ST7262 datasheet(21/139 Pages) STMICROELECTRONICS

21 / 139 page

ST7262

21/139

Figure 14. Clock block diagram

6.2 RESET

The Reset procedure is used to provide an orderly

software start-up or to exit low power modes.

Three reset modes are provided: a low voltage re-

set, a watchdog reset and an external reset at the

RESET pin.

A reset causes the reset vector to be fetched from

addresses FFFEh and FFFFh in order to be loaded

into the PC and with program execution starting

from this point.

An internal circuitry provides a 514 CPU clock cy-

cle delay from the time that the oscillator becomes

active.

6.2.1 Low Voltage Reset

Low voltage reset circuitry generates a reset when

VDD is:

■ below VIT+ when VDD is rising,

■ below VIT- when VDD is falling.

During low voltage reset, the RESET pin is held low,

thus permitting the MCU to reset other devices.

Notes:

The Low Voltage Detector can be disabled by set-

ting the LVD bit of the Option byte.

It is recommended to make sure that the VDD supply

voltage rises monotonously when the device is ex-

iting from Reset, to ensure the application functions

properly.

6.2.2 Watchdog Reset

When a watchdog reset occurs, the RESET pin is

pulled low permitting the MCU to reset other devic-

es as when low voltage reset (Figure 15).

6.2.3 External Reset

The external reset is an active low input signal ap-

plied to the RESET pin of the MCU.

As shown in Figure 18, the RESET signal must

stay low for a minimum of one and a half CPU

clock cycles.

An internal Schmitt trigger at the RESET pin is pro-

vided to improve noise immunity.

Figure 15. Low Voltage Reset functional Diagram

to CPU and

fCPU 8/4/2/1 MHz

6 MHz (USB)

12 or

peripherals

OSC12/6

6 MHz

Crystal

Slow

Mode

SMS[1:0]

1/2/4/8

(or 4/2/1/0.5 MHz)

MCO pin

LOW VOLTAGE

VDD

FROM

WATCHDOG

RESET

INTERNAL

RESET

ST7262 数据表(PDF) 21 Page - STMicroelectronics

ST7262 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载