eni =

en +

2

ei +

2

et

2

LMP2234

www.ti.com

SNOSAW4D – SEPTEMBER 2007 – REVISED MARCH 2013

APPLICATION INFORMATION

LMP2234

The LMP2234 is a quad CMOS precision amplifier that offers low offset voltage, low offset voltage drift, and high

gain while consuming less than 10

μA of supply current per channel.

The LMP2234 is a micropower op amp, consuming only 36

μA of current. Micropower op amps extend the run

time of battery powered systems and reduce energy consumption in energy limited systems. The ensured supply

voltage range of 1.8V to 5.5V along with the ultra-low supply current extend the battery run time in two ways. The

extended power supply voltage range of 1.8V to 5.5V enables the op amp to function when the battery voltage

has depleted from its nominal value down to 1.8V. In addition, the lower power consumption increases the life of

the battery.

The LMP2234 has input referred offset voltage of only ±150

μV maximum at room temperature. This offset is

ensured to be less than ±230

μV over temperature. This minimal offset voltage along with very low TCVOS of only

0.3 µV/°C typical allows more accurate signal detection and amplification in precision applications.

The low input bias current of only ±20 fA gives the LMP2234 superiority for use in high impedance sensor

applications. Bias current of an amplifier flows through source resistance of the sensor and the voltage resulting

from this current flow appears as a noise voltage on the input of the amplifier. The low input bias current enables

the LMP2234 to interface with high impedance sensors while generating negligible voltage noise. Thus the

LMP2234 provides better signal fidelity and a higher signal-to-noise ratio when interfacing with high impedance

sensors.

Texas Instruments is heavily committed to precision amplifiers and the market segments they serve. Technical

support and extensive characterization data is available for sensitive applications or applications with a

constrained error budget.

The operating voltage range of 1.8V to 5.5V over the extensive temperature range of

−40°C to 125°C makes the

LMP2234 an excellent choice for low voltage precision applications with extensive temperature requirements.

The LMP2234 is offered in the 14-pin TSSOP and 14-pin SOIC package. These small packages are ideal

solutions for area constrained PC boards and portable electronics.

TOTAL NOISE CONTRIBUTION

The LMP2234 has very low input bias current, very low input current noise, and low input voltage noise for

micropower amplifiers. As a result, this amplifier makes a great choice for circuits with high impedance sensor

applications.

shows the typical input noise of the LMP2234 as a function of source resistance at f = 1 kHz where:

•

en denotes the input referred voltage noise

•

ei is the voltage drop across source resistance due to input referred current noise or ei = RS* in

•

et shows the thermal noise of the source resistance

•

eni shows the total noise on the input.

Where:

(1)

The input current noise of the LMP2234 is so low that it will not become the dominant factor in the total noise

unless source resistance exceeds 300 M

Ω, which is an unrealistically high value. As is evident in Figure 47, at

lower RS values, total noise is dominated by the amplifier’s input voltage noise. Once RS is larger than 100 kΩ,

then the dominant noise factor becomes the thermal noise of RS. As mentioned before, the current noise will not

be the dominant noise factor for any practical application.

Copyright © 2007–2013, Texas Instruments Incorporated

Submit Documentation Feedback

17

Product Folder Links: LMP2234