AD-ICD

2 Configuring the ICD adapter

5/15

2

Configuring the ICD adapter

The following sections provide instructions about configuring your ICD adapter for

In-circuit

debugging or to Run the application in standalone mode. Delivered from the factory, the AD-

ICD/DS8Z-01 is configured as follows:

Caution:

When configuring the ICD adapter, make sure that the ICD tool and application board (if

connected to the adapter) are powered off.

2.1

In-circuit debugging

ICD On jumper (TP1)

When in-circuit debugging the target application via the 10-pin ICC connection, the ICD On

jumper (TP1) must be fitted to allow the interface with an in-circuit debugging tool and the

host PC. During in-circuit debugging, the

Table 1.

Default configuration of the AD-ICD/DS8Z-01 from factory

Identifier on

ICD adapter

Configuration

Purpose

Jumpers

TP1

Fitted

Allow connection for in-circuit

debugging/programming

TP2

Not fitted

Run application in standalone mode

Solder points

G1

Soldered

Connects tool to the microcontroller’s VDD pin

(accommodate tools with a power supply

follower)

G2

Not soldered

Connect tool’s clock signal to microcontroller’s

CLKIN pin

Figure 3.

ICD On jumper (TP1)

To set the ICD On jumper (TP1):

1.

Make sure the in-circuit debugging tool

and the application are powered off.

2.

Place the jumper on TP1 as shown in

Figure 3.

3.

Connect to and power on the in-circuit

debugging tool and application board.

Refer to the on-line help of your integrated

development environment/debugging

software for further information about in-

circuit programming and debugging the

microcontroller on the ICD adapter.

TP1 fitted for ICD

TP2 not fitted

for ICD

MB509