CC1010-RTY1 datasheet(4/150 Pages) TI2

4 / 150 page

CC1010

SWRS047A

Page 4 of 146

1. Features

Fully Integrated UHF RF Transceiver

• Programmable frequency in the

range 300 – 1000 MHz

• High sensitivity (typically -107 dBm

at 2.4 kBaud)

• Programmable output power –20 to

+10 dBm

• Very low current consumption (RX:

9.1 mA)

• Very few external components

required and no external RF switch

or IF filter required

• Single port antenna connection

• Fast PLL settling allows frequency

hopping protocols

• FSK modulation with a data rate of

up to 76.8 kBaud

• Manchester or NRZ coding and

decoding

data

performed

hardware. Byte delineation of data

can be performed in hardware to

lessen the processor burden

• RSSI output which can be sampled

by on-chip ADC

• Complies with EN 300 220 and FCC

CFR47 part 15

High-Performance and Low-Power

8051-Compatible Microcontroller

• Optimised 8051-core which typically

gives 2.5x the performance of a

standard 8051

• Dual data pointers

• Idle and sleep modes

• In-circuit interactive debugging is

supported for the Keil

µVision IDE

through a simple serial interface

Data and Non-volatile Program Memory

• 32 kB of non-volatile Flash memory

in-system programmable through a

simple SPI interface or by the 8051

core.

• Typical Flash memory endurance:

20 000 write/erase cycles

• Programmable read and write lock of

portions of Flash memory for software

security

• 2048 + 128 Byte of internal SRAM

Hardware DES Encryption / Decryption

• DES supported in hardware

• Output Feedback Mode or Cipher

Feedback Mode DES to avoid the

requirement that data length must

be a multiple of eight bytes

Peripheral Features

• Power On Reset / Brown-Out

Detection

• Three channel, max 23 kSample/s,

10 bit ADC

• Programmable watchdog timer.

• Real time clock with 32 kHz crystal

oscillator

• Two timers / pulse counters and two

timers / pulse width modulators

• Two programmable serial UARTs.

• Master SPI interface

• 26 configurable general-purpose

I/O-pins

• Random bit generator in hardware

Low Power

• 8051 core and peripherals can use

the RTC's 32 kHz clock

• Idle and sleep modes for reduced

power consumption. System can

wake up on interrupt or when ADC

input exceeds a set threshold

• Low-power fully static CMOS design

Operating Conditions

• 2.7 - 3.6 V supply voltage

• -40 - 85 °C operational temperature

• 3 - 24 MHz crystal (up to 50 ppm)

for the main crystal oscillator

Packaging

• 64-lead TQFP

CC1010-RTY1 数据表(PDF) 4 Page - Texas Instruments

CC1010-RTY1 数据表(HTML) 4 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载