ADV3003ACPZ-R7 datasheet(3/16 Pages) AD

3 / 16 page

ADV3003

Rev. 0 | Page 3 of 16

SPECIFICATIONS

TA = 27°C, AVCC = 3.3 V, VTTI = 3.3 V, VTTO = 3.3 V, AVEE = 0 V, differential input swing = 1000 mV, pattern = PRBS 27 − 1,

data rate = 2.25 Gbps, TMDS outputs terminated with external 50 Ω resistors to 3.3 V, unless otherwise noted.

Table 1.

Parameter

Conditions/Comments

Min

Typ

Max

Unit

DYNAMIC PERFORMANCE

Maximum Data Rate (DR) per Channel

NRZ

2.25

Gbps

Bit Error Rate (BER)

PRBS 223 − 1

10−9

Added Deterministic Jitter

DR ≤ 2.25 Gbps, PRBS 27 − 1

ps (p-p)

Added Random Jitter

ps (rms)

Differential Intrapair Skew

At output

Differential Interpair Skew1

At output

EQUALIZATION PERFORMANCE

Receiver (Fixed Setting)2

Boost frequency = 1.125 GHz

Transmitter (Pre-Emphasis On)3

Boost frequency = 1.125 GHz

INPUT CHARACTERISTICS

Input Voltage Swing

Differential

150

1200

Input Common-Mode Voltage (VICM)

AVCC − 800

AVCC

OUTPUT CHARACTERISTICS4

High Voltage Level

Single-ended high speed channel

AVCC − 200

AVCC + 10

Low Voltage Level

Single-ended high speed channel

AVCC − 600

AVCC − 400

Rise/Fall Time (20% to 80%)

178

TERMINATION

Input Termination Resistance

Single-ended

Output Termination Resistance

Single-ended

POWER SUPPLY

AVCC

Operating range (3.3 V ± 10%)

3.3

3.6

QUIESCENT CURRENT

AVCC

Output disabled

Output enabled, pre-emphasis off

Output enabled, pre-emphasis on

VTTI

Input termination on5

VTTO

Output termination on, pre-emphasis off

Output termination on, pre-emphasis on

100

Output disabled

POWER DISSIPATION6

Output disabled

148

Output enabled, pre-emphasis off

370

553

Output enabled, pre-emphasis on

686

937

PARALLEL CONTROL INTERFACE

TX_EN, PE_EN

Input High Voltage, VIH

Input Low Voltage, VIL

0.8

1 Differential interpair skew is measured between the TMDS pairs of the HDMI/DVI link.

2 ADV3003 output meets the transmitter eye diagram mask as defined in the HDMI Standard Version 1.3a and the DVI Standard Version 1.0.

3 Cable output meets the receiver eye diagram mask as defined in the HDMI Standard Version 1.3a and the DVI Standard Version 1.0.

4 PE = 0 dB.

5 Typical value assumes the HDMI/DVI link is active with nominal signal swings. Minimum and maximum limits are measured at the extremes of input termination

resistance and input voltage swing, respectively .

6 The total power dissipation excludes power dissipated in the 50 Ω off-chip loads.

ADV3003ACPZ-R7 数据表(PDF) 3 Page - Analog Devices

ADV3003ACPZ-R7 数据表(HTML) 3 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

数据表下载

链接网址

ADV3003ACPZ-R7 数据表(PDF) 3 Page - Analog Devices

ADV3003ACPZ-R7 数据表(HTML) 3 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

数据表 下载

链接网址

数据表下载