4 - Redundancy unit CP-C.1-A-RU | Data sheet

In operation pay attention to:

– Do not modify the installation (primary and secondary side)! High current! Risk of electric

arcs and electric shock (danger to life)!

– Risk of burns: Depending on the operation conditions the housing can become hot.

– The device contains no user serviceable parts. In any case of device malfunction please

send the unit back to manufacturer.

The device must be installed by qualified persons only and in accordance with the specific

national regulations (e. g. VDE, etc.).

The CP-C.1 is a chassis-mounted unit. It is maintenance-free and does not contain any

integral setting elements and should therefore not be opened.

Before any installation, maintenance or modification work:

– Read the operating and installation instructions carefully and completely!

– Disconnect the system from the supply network and protect against switching on!

Before start of operation the following must be ensured:

– Connection to mains or DC supply according to the specific national regulations for class

of protection I.

– Power supply cables and unit must be sufficiently fused. A disconnecting device has to

be provided for the end product to disengage unit and supply cables from supply mains

if required.

– The protective earth conductor must be connected to the terminal PE.

– Rate the output lines for the output current of the power supply and connect them with

the correct polarity.

– In order to ensure sufficient convection the distance to the other devices has to be

considered.

Attention! Improper installation/operation may impair safety of personnel and cause

operational difficulties or destruction of the unit.

Attention! Danger to life!

Disconnect the system from the supply network before executing any works at the device

and protect against switching on! The power supply contains components with high stored

energy and circuits with high voltage! Do not introduce any objects into the unit and do not

open the unit.

With some units of this range the output is capable of providing hazardous energy. Ensure

that the service personnel is protected against inadvertent contact with parts carrying

energy.

If the internal fuse is blown most probably the device is defect. In this case an examination

of the device by the manufacturer is necessary.

Safety instructions and warnings