8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

starting stage and the 12V LED indicator will be stable green and the

starting/connection indicator will flash green. When the vehicle battery

voltage is detected between 15.5V and 30V, the jumpstarter will

automatically set to the 24V starting stage and the 24V LED indicator will

be a stable green and the starting/connection indicator will flash green.

5. When the connection indicator starts flashing, press the On/Off button, this

will turn the indicator to a stable solid green and the system will be ready

for use.

NOTE: If you do not achieve the above, consult the chart below.

STARTING/CONNECTION INDICTOR CHART

6. Attempt the vehicle ignition sequence. Duration of ignition should not

exceed 5 seconds to avoid overheating.

7. If the vehicle does not start successfully, wait 3 minutes before trying again.

8. If the vehicle starts, push the On/Off button to turn the jumpstarter off and

disconnect the clamps, with the black clamp removed first.

9. Recharge the jumpstarter after each use.

10. If ignition waiting time exceeds 3 minutes, the jumpstarter will automatically

turn itself off. Push the On/Off button or reconnect the clamps for the next

jumpstart.

Green

LED

Red

LED

Sound

Description

1

On

Off

Off

Correct connections, jumpstarting enabled

2

Flashing

Off

Off

Correct connections, ready for jumpstart by

pressing the On/Off button

3Off

Fast

Flashing

On

Wrong connection (Reverse Polarity),

reconnect clamps correctly

4Off

Slow

Flashing

On

Vehicle battery over voltage, not suitable for

jumpstarting

5Slow

Flashing

Off

On

Override is activated for jumpstarting

6

Off

On

On

Short circuit connection, warning under

override