9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

TEMPERATURE INDICTOR CHART

OVERRIDE JUMPSTARTING

A battery with some charge must be connected to the vehicle circuit in order

for the jumpstarter to select a start voltage. If the terminals are bad/loose fit on

the battery, or the battery is so low as not to register a voltage then the

jumpstarter will not select or provide a voltage. To override this issue carry out

the following:

1. Tighten all connections and terminations on the vehicle battery.

2. Ensure the clamps are correctly connected to the battery terminals.

3. Press the On/Off button for 10 seconds, the

start/connection indicator will flash and

there will be a warning sound. This will put

the jumpstarter into the override start

mode.

NOTE: Override for 24V Battery. When a 24V

battery is lower than 15.5V, the

jumpstarter will only activate on 12V

mode. To turn the jumpstarter to 24V

mode, press the 24V Manual Shift

Button for 10 seconds.

4. Attempt the vehicle ignition sequence.

Duration of ignition should not exceed 5

seconds to avoid overheating.

5. If the vehicle does not start successfully, wait 3 minutes before trying again.

6. If the vehicle starts, push the On/Off button to turn the jumpstarter off and

disconnect the clamps, with the black clamp removed first.

7. Recharge the jumpstarter after each use.

Red

LED

Sound Description

1Off

Off

Normal

Temperature,

enabled for

jumpstarting

2On

On

Over Temperature,

DO NOT USE for

jumpstarting