2192-09099-000-000
Page 8
J591 APCI-IB40
Installation for CE Compliance
To maintain compliance with the requirements of the EMC directive (89/336/EEC), this product must
be correctly installed. The PC system in which the board is housed must be CE compliant as declared
by the manufacturer. The type of external I/O cable required can be chosen according to the notes
below:
1. Remove the cover of the PC observing any additional instructions of the PC manufacturer.
2. Locate the board in a spare PCI slot and press gently but firmly into place.
3. Ensure that the metal bracket attached to the board is fully seated.
4. fit the bracket clamping screw and firmly tighten this on the bracket.
Note:- Good contact of the bracket to the chassis is essential.
5. Replace the cover of the PC observing any additional instructions of the PC manufacturer.
Cable
Cable length 1 Metre or less
: Ribbon cable satisfactory.
Cable 1 Metre to 3 Meters
: Commerial screened cable.
> 3 Meters or noisy environment : Use fully screened cable with metal backshells
e.g. Arcom CAB50CE
The following standards have been applied to this product:
BS EN50081-1
: 1992 Generic Emissions Standard, Residential, Commercial, Light Industry
BS EN50082-1 : 1992 Generic Immunity Standard, Residential, Commercial, Light Industry
BSEN55022
: 1995 ITE Emissions, Class B, Limits and Methods.
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
