ST14C02C datasheet(2/12 Pages) STMICROELECTRONICS

2 / 12 page

ST14C02C

2/12

Figure 2. D15 Contact Connections

AI02492

VCC

GND

SCL

SDA

Figure 3. D20 Contact Connections

AI02491

VCC

GND

SCL

SDA

MODE

The memory behaves as a slave device in the I2C

protocol, with all memory operations synchronized

by the serial clock. Read and write operations are

initiated by a START condition, generated by the

bus master. The START condition is followed by

the Device Select Code which is composed of a

stream of 7 bits (1010000), plus one read/write bit

(R/W) and is terminated by an acknowledge bit.

When writing data to the memory, the memory in-

serts an acknowledge bit during the 9th bit time,

following the bus master’s 8-bit transmission.

When data is read by the bus master, the bus

master acknowledges the receipt of the data byte

in the same way. Data transfers are terminated by

a STOP condition after an Ack for WRITE, and af-

ter a NoACK for READ.

Power On Reset: VCC Lock-Out Write Protect

In order to prevent data corruption and inadvertent

write operations during power up, a Power On Re-

set (POR) circuit is included. The internal reset is

held active until the VCC voltage has reached the

POR threshold value, and all operations are dis-

abled – the device will not respond to any com-

mand. In the same way, when VCC drops from the

operating voltage, below the POR threshold value,

all operations are disabled and the device will not

respond to any command. A stable and valid VCC

must be applied before applying any logic signal.

Table 2. Absolute Maximum Ratings 1

Note: 1. Except for the rating “Operating Temperature Range”, stresses above those listed in the Table “Absolute Maximum Ratings” may

cause permanent damage to the device. These are stress ratings only, and operation of the device at these or any other conditions

above those indicated in the Operating sections of this specification is not implied. Exposure to Absolute Maximum Rating condi-

tions for extended periods may affect device reliability. Refer also to the ST SURE Program and other relevant quality documents.

2. MIL-STD-883C, 3015.7 (100 pF, 1500

Ω)

3. EIAJ IC-121 (Condition C) (200 pF, 0

Ω)

Symbol

Parameter

Value

Unit

Ambient Operating Temperature

0 to 70

°C

TSTG

Storage Temperature

Wafer form

Module form

-65 to 150

-40 to 120

°C

VIO

Input or Output range

-0.3 to 6.5

VCC

Supply Voltage

-0.3 to 6.5

VESD

Electrostatic Discharge Voltage (Human Body model) 2

4000

Electrostatic Discharge Voltage (Machine model) 3

500

ST14C02C 数据表(PDF) 2 Page - STMicroelectronics

ST14C02C 数据表(HTML) 2 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

数据表下载