ST62T28C datasheet(38/84 Pages) STMICROELECTRONICS

38 / 84 page

38/84

ST62T28C/E28C

I/O PORTS (Cont’d)

4.1.3 ARTimer alternate functions

When bit PWMOE of register ARMC is low, pin AR-

TIMout/PA2 is configured as any standard pin of

port B through the port registers. When PWMOE is

high, ARTIMout/PA2 is the PWM output, independ-

ently of the port registers configuration. ARTIMin/

PA3 is connected through the port registers as any

standard pin of port B. To use PARTIMin/PA3 as

AR Timer input, it must be configured as input

though DDRB.

4.1.4 SPI alternate functions

PD2/Sin and PD1/Scl pins must be configured as

input through the DDR and OR registers to be

used as data in and data clock (Slave mode) for

the SPI. All input modes are available and I/O’s

can be read independently of the SPI at any time.

PD3/Sout must be configured in open drain output

mode to be used as data out for the SPI. In output

mode, the value present on the pin is the port data

output, while serial transmission is possible only in

open drain mode.

4.1.5 UART alternate functions

PD4/RXD1 pin must be configured as input

through the DDR and OR registers to be used as

reception line for the UART. All input modes are

available and PD4 can be read independently of

the UART at any time.

PD5/TXD1 pin must be configured as output

through the DDR and OR registers to be used as

transmission line for the UART. Value present on

the pin in output mode is the Data register content

as long as no transmission is active.

ST62T28C 数据表(PDF) 38 Page - STMicroelectronics

ST62T28C 数据表(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载