TDA7513T datasheet(31/84 Pages) STMICROELECTRONICS

31 / 84 page

TDA7513T

Functional description

31/84

A few programmable phase errors (D0, D1) are available for inlock detection. The count of

detected inlock informations to release the inlock signal is adjustable (D2, D3), to avoid

switching to low current during a frequency jump.

3.3.5

Low noise CMOS op-amp

An internal voltage divider at pin #LFREF is connected to the positive input of the low noise

op-amp. The charge pump output is connected to the negative input. This internal amplifier

in cooperation with external components provides the active loop filter. Only one loop filter

connection is provided because the same reference frequency is used for both AM and FM

operation. The pin #LFHC is connected in such a way as to partially shunt the loop filter in

order to decrease the time constant of the filter itself during jumps with high current mode

activated.

3.3.6

IF counter block

The input signal for FM and AM has the same structure although FM IF is measured at IF1

(10.7MHz) and AM IF is measured at IF2 (450kHz). The degree of integration is adjustable

to up to eight different measuring cycle times. The tolerance of the accepted count value is

adjustable to reach the optimum compromise between search speed and evaluation

precision.

T center frequency of the measured count value is adjustable to fit the IF-filter tolerance.

3.3.7

The IF counter mode

The IF counter works in 2 modes controlled by the IFCM register.

3.3.8

Sampling timer

A 14-bit programmable (IRC) sampling timer generates the gate signal for the main counter.

In FM mode a 6.25kHz frequency reference is generated for this purpose, whereas in AM

mode this reference becomes 1kHz. These reference frequencies are further divided to

generate the measurement time windows (160us - 320

μs ... 20.48ms for FM, 1ms - 2ms …

128ms for AM).

3.3.9

Intermediate frequency main counter

This counter is a 11 - 21-bit synchronous autoreload down counter. Five bits (CF) are

programmable to allow the adjustment to the peak of the IF-filter response. The counter

length is automatically adjusted to the chosen sampling time and counter mode (FM, AM).

The IF counter is also used to automatically perform the stereo decoder 456kHz VCO

frequency adjustment.

At the start the counter will be loaded with a value equivalent to the expected number of

zero-crossing in the sampling time window (tSample x fIF ). If the correct frequency is applied

to the IF counter input, at the end of the sampling time the main counter will have either a 0h

state or a 1FFFFFh state stored.

A deviation from the expected IF will result in a difference of the counter final state from

either of these values. The counter final state is then compared to either 0h or 1FFFFFh

minus a number of LSB's determined by the acceptable frequency window programming

(EW).

TDA7513T 数据表(PDF) 31 Page - STMicroelectronics

TDA7513T 数据表(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载