STPC0380BTI3 datasheet(30/51 Pages) STMICROELECTRONICS

30 / 51 page

ELECTRICAL SPECIFICATIONS

30/51

Issue 1.2

4. ELECTRICAL SPECIFICATIONS

4.1 Introduction

The electrical specifications in this chapter are val-

id for the STPC Consumer.

4.2 Electrical Connections

4.2.1 Power/Ground Connections/Decoupling

Due to the high frequency of operation of the

STPC Consumer, it is necessary to install and test

this device using standard high frequency tech-

niques. The high clock frequencies used in the

STPC Consumer and its output buffer circuits can

cause transient power surges when several output

buffers switch output levels simultaneously. These

effects can be minimized by filtering the DC power

leads with low-inductance decoupling capacitors,

using low impedance wiring, and by utilizing all of

the VSS and VDD pins.

4.2.2 Unused Input Pins

All inputs not used by the designer and not listed

in the table of pin connections in Chapter 3 should

be connected either to VDD or to VSS. Connect

active-high inputs to VDD through a 20 k

Ω (±10%)

pull-down resistor and active-low inputs to VSS

and connect active-low inputs to VCC through a

20 k

Ω (±10%) pull-up resistor to prevent spurious

operation.

4.2.3 Reserved Designated Pins

Pins designated reserved should be left discon-

nected. Connecting a reserved pin to a pull-up re-

sistor, pull-down resistor, or an active signal could

cause unexpected results and possible circuit

malfunctions.

4.3 Absolute Maximum Ratings

The following table lists the absolute maximum

ratings for the STPC Consumer device. Stresses

beyond those listed under Table 4-1 limits may

cause permanent damage to the device. These

are stress ratings only and do not imply that oper-

ation under any conditions other than those spec-

ified in section ”Operating Conditions”.

Exposure to conditions beyond Table 4-1 may (1)

reduce device reliability and (2) result in prema-

ture failure even when there is no immediately ap-

parent sign of failure. Prolonged exposure to con-

ditions at or near the absolute maximum ratings

(Table 4-1) may also result in reduced useful life

and reliability.

Table 4-1. Absolute Maximum Ratings

Symbol

Parameter

Value

Units

VDDx

DC Supply Voltage

-0.3, 4.0

VI,VO

Digital Input and Output Voltage

-0.3, VDD + 0.3

TSTG

Storage Temperature

-40, +150

°C

TOPER

Operating Temperature

0, +70

°C

PTOT

Total Power Dissipation

4.8

STPC0380BTI3 数据表(PDF) 30 Page - STMicroelectronics

STPC0380BTI3 数据表(HTML) 30 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

数据表下载