LTC4306

4306f

8

Control Register Bit Definitions

OPERATIO

Register 0 (00h)

BIT NAME

TYPE* DESCRIPTION

d7 Downstream

R

Indicates if upstream bus is connected

Connected

to any downstream buses

0 = upstream bus disconnected from

all downstream buses

1 = upstream bus connected to one or

more downstream buses

d6 ALERT1 Logic State

R

Logic state of ALERT1 pin, noninverting

d5 ALERT2 Logic State

R

Logic state of ALERT2 pin, noninverting

d4 ALERT3 Logic State

R

Logic state of ALERT3 pin, noninverting

d3 ALERT4 Logic State

R

Logic state of ALERT4 pin, noninverting

d2 Failed Connection

R

Indicates if an attempt to connect to a

Attempt

downstream bus failed because the

“Connection Requirement” bit in

Register 2 was low and the

downstream bus was low

0 = Failed connection attempt occurred

1 = No failed attempts at connection

occurred

d1 Latched Timeout

R

Latched bit indicating if a timeout has

occurred and has not yet been cleared.

0 = no latched timeout

1 = latched timeout

d0 Timeout Real Time

R

Indicates real-time status of Stuck Low

Timeout Circuitry

0 = no timeout is occurring

1 = timeout is occurring

Note: Masters write to Register 0 to reset the fault circuitry after a fault

has occurred and been resolved. Because Register 0 is Read-Only, no

other functionality is affected.

* For Type, “R/W” = Read Write, “R” = Read Only

Register 1 (01h)

BIT

NAME

TYPE* DESCRIPTION

d7

Upstream

R/W

Activates upstream rise time

Accelerators

accelerator currents

Enable

0 = upstream rise time accelerator

currents inactive (default)

1 = upstream rise time accelerator

currents active

d6

Downstream

R/W

Activates downstream rise time

Accelerators

accelerator currents

Enable

0 = downstream rise time accelerator

currents inactive (default)

1 = downstream rise time accelerator

currents active

d5

GPIO1 Output

R/W

GPIO1 output driver state,

Driver State

noninverting, default = 1

d4

GPIO2 Output

R/W

GPIO2 output driver state,

Driver State

noninverting, default = 1

d3-d2 Reserved

R

Not Used

d1

GPIO1 Logic

R

Logic state of GPIO1 pin,

State

noninverting

d0

GPIO2 Logic

R

Logic state of GPIO2 pin,

State

noninverting

* For Type, “R/W” = Read Write, “R” = Read Only