MPC8378CVRALDA datasheet(55/126 Pages) FREESCALE

55 / 126 page

MPC8378E PowerQUICC™ II Pro Processor Hardware Specifications, Rev. 2

Freescale Semiconductor

Enhanced Secure Digital Host Controller (eSDHC)

This means that data delay should be equal or less than the clock delay in the ideal case where

tSHSCLKL =10 ns:

tDATA_DELAY – tCLK_DELAY < 10 – 6 – 4

tDATA_DELAY – tCLK_DELAY < 0

11.3.1.2

High-Speed Write Meeting Hold (Minimum Delay)

The following equations show how to calculate the allowed skew range between the SD_CLK and

SD_DAT/CMD signals on the PCB.

tCLK_DELAY < tSHSCKL + tSHSKHOX + tDATA_DELAY – tIH

tCLK_DELAY – tDATA_DELAY < tSHSCKL + tSHSKHOX – tIH

This means that clock can be delayed versus data up to 8 ns (external delay line) in ideal case of

tSHSCLKL =10 ns:

tCLK_DELAY – tDATA_DELAY < 10 + 0 – 2

tCLK_DELAY – tDATA_DELAY < 8

11.3.2

High-Speed Input Path (Read)

Figure 35 provides the data and command input timing diagram.

Figure 35. High Speed Input Path

For the input path, the device eSDHC expects to sample the data 1.5 internal clock cycles after it was

driven by the SD card. Since in this mode the SD card drives the data at the rising edge of the clock, a

sufficient delay to the clock and the data must exist to ensure it will not be sampled at the wrong internal

clock falling edge. Note that the internal clock which is guaranteed to be 50% duty cycle is used to sample

the data, and therefore used in the equations.

tCLK_DELAY

Output from the

SD CLK at

the Card Pin

SD Card Pins

tSHSIVKH

Driving

Edge

Sampling

Edge

tOH

tDATA_DELAY

tODLY

tSHSCK (Clock Cycle)

1/2 Cycle

tSHSIXKH

Right Edge

Wrong Edge

(MPC8378E Input Hold)

(MPC8378E Input Setup)

Input at the

MPC8378E Pins

SD CLK at the

MPC8378E Pin

MPC8378CVRALDA 数据表(PDF) 55 Page - Freescale Semiconductor, Inc

MPC8378CVRALDA 数据表(HTML) 55 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载