| 数据搜索系统,热门电子元器件搜索 |
|
LSM320HAY30 数据表(PDF) 18 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
LSM320HAY30 数据表(HTML) 18 Page - STMicroelectronics |
|
18 / 42 page ![]() Application hints LSM320HAY30 18/42 Doc ID 16917 Rev 1 The device core is supplied through the Vdd line. Power supply decoupling capacitors (C1=100 nF ceramic, C2=10 µF aluminum) should be placed as near as possible to the supply pin of the device (common design practice). All voltage and ground supplies must be present at the same time to obtain proper behavior of the IC (refer to Figure 3). 5.1 Linear acceleration sensing The functionality of the device and the measured acceleration data is selectable and accessible through the SPI/I2C interface. The functions, the threshold and the timing of the two interrupt pins (INT 1 and INT 2) can be completely programmed by the user though the SPI/I2C interface. 5.2 Angular rate sensing The LSM320HAY30 allows band limitation of the output rate response through the use of an external low-pass filter (recommended) and/or high-pass filter (optional) in addition to the embedded low-pass filter (ft = 140 Hz). 4xOUTX and 4xOUTZ are, respectively, OUTX and OUTZ amplified outputs lines, internally buffered to ensure low output impedance. If external filtering is not applied, it is mandatory to short-circuit pad 18 to pad 19 and pad 23 to pad 24, respectively, when amplified outputs are used. When only a non-amplified output is used (OUTX/OUTZ), it is recommended to set pin 19 and 23 to a fixed reference voltage (Vref). The LSM320HAY30 IC includes a PLL (phase locked loop) circuit to synchronize driving and sensing interfaces. Capacitors and resistors must be added at the FILTVDD and VCONT pins (as shown in Figure 3) to implement a second-order low-pass filter. Figure 4. Angular rate output response vs. rotation Steady state position: 4xOUTX = 4xOUTZ = 1.5V OUTX = OUTZ = 1.5V Positive rotations as indicated by the arrows +300°/sec --> 4xOUTX, 4xOUTZ = 1.5V + SoA*300 = 2.5V +300°/sec --> OUTX, OUTZ = 1.5V + So*300 = 1.75V increase output value over Zero rate level: 1 Z Y 1 X Z +Ω x +Ω z AM06042v1 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |