ADP1715ARMZ-R7 datasheet(25/75 Pages) AD

25 / 75 page

ADSP-BF506F EZ-KIT Lite Evaluation System Manual

1-5

Using ADSP-BF506F EZ-KIT Lite

To connect the EZ-KIT Lite to a PC via the debug agent:

1. Plug one side of the provided USB cable into the USB connector of

the debug agent ZP1 (labeled USB). Plug the other side of the cable

into a USB port of the PC running VisualDSP++ .

2. Verify that the yellow USB monitor LED on the debug agent,

ZLED2

, is lit. This signifies that the board is communicating prop-

erly with the host PC and ready to run VisualDSP++.

EZ-KIT Lite Session Startup

1. If you are running VisualDSP++ for the first time, navigate to the

VisualDSP++ environment via the Start–>Programs menu. The

main window appears. Note that VisualDSP++ does not connect to

any session. Skip the rest of this step to step 2.

If you have run VisualDSP++ previously, the last opened session

appears on the screen. You can override the default behavior and

force VisualDSP++ to start a new session by pressing and holding

down the Ctrl key while starting VisualDSP++. Do not release the

Ctrl key until the Session Wizard appears on the screen. Go to

step 3.

2. To connect to a new EZ-KIT Lite session, start Session Wizard by

selecting one of the following.

• From the Session menu, New Session.

• From the Session menu, Session List. Then click New Ses-

sion from the Session List dialog box.

• From the Session menu, Connect to Target.

ADP1715ARMZ-R7 数据表(PDF) 25 Page - Analog Devices