Freescale Semiconductor

Data Sheet: Technical Data

Document Number: MC9S08JS16

Rev. 4, 4/2009

© Freescale Semiconductor, Inc., 2008-2009. All rights reserved.

This document contains information on a product under development. Freescale reserves the

right to change or discontinue this product without notice.

MC9S08JS16

Features:

• 8-Bit HCS08 Central Processor Unit (CPU)

– 48 MHz HCS08 CPU (central processor unit)

– 24 MHz internal bus frequency

– Support for up to 32 interrupt/reset sources

• Memory Options

– Up to 16 KB of on-chip in-circuit programmable flash

memory with block protection and security options

– Up to 512 bytes of on-chip RAM

– 256 bytes of USB RAM

• Clock Source Options

– Clock source options include crystal, resonator, external

clock

– MCG (multi-purpose clock generator) — PLL and FLL;

internal reference clock with trim adjustment

• System Protection

– Optional computer operating properly (COP) reset with

option to run from independent 1 kHz internal clock

source or the bus clock

– Low-voltage detection

– Illegal opcode detection with reset

– Illegal address detection with reset

• Power-Saving Modes

– Wait plus two stops

• USB Bootload

– Mass erase entire flash array

– Partial erase flash array — erase all flash blocks except

for the first 1 KB of flash

– Program flash

• Peripherals

– USB — USB 2.0 full-speed (12 Mbps) with dedicated

on-chip 3.3 V regulator and transceiver; supports

endpoint 0 and up to 6 additional endpoints

– SPI — One 8- or 16-bit selectable serial peripheral

interface module with a receive data buffer hardware

match function

– SCI — One serial communications interface module

with optional 13 bit break. Full duplex non-return to zero

(NRZ); LIN master extended break generation; LIN

slave extended break detection; wakeup on active edge

– MTIM — One 8-bit modulo counter with 8-bit prescaler

and overflow interrupt

– TPM — One 2-channel 16-bit timer/pulse-width

modulator (TPM) module; selectable input capture,

output compare, and edge-aligned PWM capability on

each channel; timer module may be configured for

buffered, centered PWM (CPWM) on all channels

– KBI — 8-pin keyboard interrupt module

– RTC — Real-time counter with binary- or

decimal-based prescaler

– CRC — Hardware CRC generator circuit using 16-bit

shift register; CRC16-CCITT compliancy with

• Input/Output

– Software selectable pullups on ports when used as inputs

– Software selectable slew rate control on ports when used

as outputs

– Software selectable drive strength on ports when used as

outputs

– Master reset pin and power-on reset (POR)

– Internal pullup on RESET, IRQ, and BKGD/MS pins to

reduce customer system cost

• Package Options

– 24-pin quad flat no-lead (QFN)

– 20-pin small outline IC package (SOIC)

MC9S08JS16 Series

Covers:

MC9S08JS16

MC9S08JS8

MC9S08JS16L

MC9S08JS8L

20 W-SOIC

Case 751D

24 QFN

Case 1982-01

TBD