| 数据搜索系统,热门电子元器件搜索 |
|
MIC3003 数据表(PDF) 13 Page - Micrel Semiconductor |
|
|
|||||||||||||||||||||||||||||
MIC3003 数据表(HTML) 13 Page - Micrel Semiconductor |
|
13 / 75 page ![]() Micrel, Inc. MIC3003 November 2009 13 M9999-111209-C hbwhelp@micrel.com or (408) 955-1690 Electrical Characteristics Symbol Parameter Condition Min Typ Max Units Control and Status I/O Timing, TXFAULT, TXDISABLE, RS0, RRSOUT, and RXLOS tOFF TXDISABLE Assert Time From input asserted to optical output at 10% of nominal, CCOMP = 10nF. 10 µs tON TXDISABLE De-assert Time From input de-asserted to optical output at 90% of nominal, CCOMP = 10nF. 1 ms tINIT Initialization Time From power on or transmitter enabled to optical output at 90% of nominal and TX_FAULT de-asserted. Note 10 300 ms tINIT2 Power-on Initialization Time From power on to APC loop-enabled. 200 ms tFAULT TXFAULT Assert Time From fault condition to TXFAULT assertion. Note 10 95 µs tRESET Fault Reset Time Length of time TXDISABLE must be asserted to reset fault condition. 10 µs tLOSS_ON RXLOS Assert Time From loss of signal to RXLOS asserted. 95 µs tLOSS_OFF RXLOS De-assert Time From signal acquisition to LOS de-asserted. 100 µs tDATA Analog Parameter Data Ready From power on to valid analog parameter data available. Note 10 400 ms tPROP_IN TXFAULT, TXDISABLE, RXLOS, RS0, RS1 Input Propagation Time Time from input change to corresponding internal register bit set or cleared. Note 10 1 µs tPROP_OUT TXFAULT, TRSOUT, TRRSOUT, /INT, QGPO Output Propagation Time From an internal register bit set or cleared to corresponding output change. Note 10 1 µs Fault Comparators FLTTMR Fault Suppression Timer Clock Period Note 10 0.475 0.5 0.525 ms Accuracy -3 +3 %/fs tREJECT Glitch Rejection Maximum length pulse that will not cause output to change state. Note 10 4.5 µs High level 95 %VDDA VSAT Saturation Detection Threshold Low level 5 %VDDA Power-On Hour Meter Timebase Accuracy 0°C ≤ TA ≤ +70°, Note 10 +5 -5 % –40°C ≤ TA ≤ +105°C +10 -10 % Resolution Note 10 10 hours Non-Volatile (FLASH) Memory tWR Write Cycle Time, Note 11 Measured from the SMBus STOP condition of a one-byte to eight-byte write transaction. Note 10 13 ms NVRAM Data Retention 100 years Endurance Maximum permitted number of write cycles to any single NVRAM location 10,000 cycles Notes: 10. Guaranteed by design and/or testing of related parameters. Not 100% tested in production. 11. The MIC3003 will not respond to serial bus transactions during an EEPROM write cycle. The host will receive a NACK response during tWR. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |