LTC2913 datasheet(6/16 Pages) LINER

6 / 16 page

LTC4365

4365f

PIN FUNCTIONS

Exposed Pad: Connect to device ground.

FAULT: FaultIndicationOutput.Thishighvoltageopendrain

output is pulled low if UV is below its monitor threshold,

if OV is above its monitor threshold, if SHDN is low, or if

VIN has not risen above VIN(UVLO).

GATE: Gate Drive Output for External N-channel MOSFETs.

An internal charge pump provides 20μA of pull-up current

and up to 9.8V of enhancement to the gate of an external

N-channel MOSFET.

When turned off, GATE is pulled just below the lower of

VIN or VOUT. When VIN goes negative, GATE is automati-

cally connected to VIN.

GND: Device Ground.

OV: Overvoltage Comparator Input. Connect this pin to an

external resistive divider to set the desired VIN overvoltage

fault threshold. Input to an accurate, fast (1μs) compara-

tor with a 0.5V rising threshold and 25mV of hysteresis.

When OV rises above its threshold, a 50mA current sink

pulls down on the GATE output. When OV falls back below

0.475V, and after a 36ms recovery delay waiting period,

the GATE charge pump is enabled. The low leakage current

of the OV input allows the use of large valued resistors for

the external resistive divider. Connect to GND if unused.

SHDN: Shutdown Control Input. SHDN high enables the

GATE charge pump which in turn enhances the gate of an

external N-channel MOSFET. A low on SHDN generates a

pull down on the GATE output with a 90μA current sink and

places the LTC4365 in low current mode (10μA). If unused,

connect to VIN. If VIN goes below ground, or if VIN rings to

60V, use a current limiting resistor of at least 100k.

UV: Undervoltage Comparator Input. Connect this pin

to an external resistive divider to set the desired VIN

undervoltage fault threshold. Input to an accurate, fast

(1μs) comparator with a 0.5V falling threshold and 25mV

of hysteresis. When UV falls below its threshold, a 50mA

current sink pulls down on the GATE output. When UV

rises back above 0.525V, and after a 36ms recovery

delay waiting period, the GATE charge pump is enabled.

The low leakage current of the UV input allows the use

of large valued resistors for the external resistive divider.

If unused, connect to VIN. While connected to VIN, if VIN

goes below ground, or if VIN rings to 60V, use a current

limiting resistor of at least 100k.

VIN: Power Supply Input. Maximum protection range:

–40V to 60V. Operating range: 2.5V to 34V.

VOUT: Output Voltage Sense Input. This pin senses the volt-

age at the output side of the external N-channel MOSFET.

The GATE charge pump voltage is referenced to VOUT. It

is used as the charge pump input when VOUT is greater

than approximately 6.5V.

LTC2913 数据表(PDF) 6 Page - Linear Technology

LTC2913 数据表(HTML) 6 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

数据表下载