PCF8564A datasheet(40/45 Pages) NXP

40 / 45 page

PCF8564A

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 02 — 30 September 2010

40 of 45

NXP Semiconductors

PCF8564A

Real time clock and calendar

Device removal can be done when the substrate is heated until it is certain that all solder

joints are molten. The chip can then be carefully removed from the substrate without

damaging the tracks and solder lands on the substrate. Removing the device must be

done using plastic tweezers, because metal tweezers can damage the silicon. The

surface of the substrate should be carefully cleaned and all solder and flux residues

and/or underfill removed. When a new chip is placed on the substrate, use the flux

process instead of solder on the solder lands. Apply flux on the bumps at the chip side as

well as on the solder pads on the substrate. Place and align the new chip while viewing

with a microscope. To reflow the solder, use the solder profile shown in application note

AN10365 “Surface mount reflow soldering description”.

19.3.4 Cleaning

Cleaning can be done after reflow soldering.

PCF8564A 数据表(PDF) 40 Page - NXP Semiconductors