DS80C310

12 of 22

Note 6:

When addressing external memory. This specification applies to the first clock cycle following the transition. On subsequent

cycles following 1 to 0 transitions, the typical current sink capability of Port 0 and Port 2 is approximately 150

A, and the

minimum current sink capability of ALE and

PSEN is approximately 400

A. On subsequent cycles following 0 to 1

transitions, the typical current drive capability of Port 0 and Port 2 is approximately 110

A.

Note 7:

Note 8:

During a 0 to 1 transition, a one-shot drives the ports hard for two clock cycles. This measurement reflects port in transition

mode.

Note 9:

Current required from external circuit to hold a logic-low level on an I/O pin while the corresponding port latch bit is set to 1.

This is only the current required to hold the low level; transitions from 1 to 0 on an I/O pin must also overcome the transition

current.

Note 10:

Ports 1 and 3 source transition current when being pulled down externally. The current reaches its maximum at approximately

2V.

Note 11:

address bus on the DS80C310. Peak current occurs near the input transition point of the latch, approximately 2V.