POE576U-4MP-N-R datasheet(33/45 Pages) PHIHONG

33 / 45 page

Phihong USA Corporation • 47800 Fremont Blvd. Fremont, CA 94538 • Tel: 1.510.445.0100 Fax: 1.510.445.1678

www.phihong.com or www.midspans.com

-33-

4.4

Using MG-SOFT MIB Browser to run Phihong Midspan

As an example, we have detailed instructions on how to operate a Phihong Midspan using the MG-

SOFT MIB browser. These instructions do not apply to all MIB browsers, please see instructions for

your speciﬁc browser if you don’t want to use this software.

4.4.1 Generate Phihong-POE-MIB module

It is assumed that MG-Soft MIB browser is already installed on your PC. For detailed operation

information, users can get help by choosing from the menu Help » User Manual when the MG-SOFT

MIB Browser is opened.

1. Open the MIB Browser and click the Continue button on the Welcome popup window. A Tip

of the Day window may pop-up for certain options in this browser. Users may choose to click

the little box in the lower left hand corner to stop these pop-ups.

2. Click the MIB tab; remove any MIB modules in the “Loaded MIB modules” by highlighting and

double clicking them.

3. Under the Action menu - open Run MIB Compiler.

4. In the MG-SOFT MIB Compiler window, click File then Compile…… then in the Open window,

browse for and open PHIHONG-POE-MIB.txt (users can get SNMP MIB rev 10/30/09 from the

support section on either www.phihong.com or www.midspans.com).

5. If compiling is successful, a Compiled MIB Modules window will be displayed. Click Save All

and click OK on the Browse for Folder window.

6. Close the MG-SOFT MIB Compiler window.

7. In the MG-SOFT MIB Browser window, click the circular arrow button (the middle one of 5

buttons right below the Loaded MIB modules window). This will update the MIB Browser

windows’ contents (including the newly compiled MIB module Phihong-POE-MIB).

8. In the lower window, click the tab MIB Modules. Locate the module < Phihong-POE-MIB >.

Highlighting and double clicking it will load it into the upper Loaded MIB modules window.

9. Also locate <RFC1213-MIB> and <SNMPv2-MIB>, load them into the upper Loaded MIB

modules window.

10. Now the setup for Phihong’s Midspan SNMP interface is complete.

POE576U-4MP-N-R 数据表(PDF) 33 Page - Phihong USA Inc.