POE576U-4MP-N-R datasheet(32/45 Pages) PHIHONG

32 / 45 page

Phihong USA Corporation • 47800 Fremont Blvd. Fremont, CA 94538 • Tel: 1.510.445.0100 Fax: 1.510.445.1678

www.phihong.com or www.midspans.com

-32-

1.3.6.1.4.1.24852.1.4.33

port8status

Read-

Only

Display

port8 status

1.3.6.1.4.1.24852.1.4.34

modelName

Read-

Only

DisplayString

Display

device’s

Model

Name

4.3 Notes for using Phihong Midspan MIB

1. Although Phihong midspans using SNMPv2c protocol can also run under a SNMPv1 console with

the same MIB ﬁle, they will not operate with Phihong’s SNMPv3 MIB, as the MIB ﬁles are not the

same.

2. There is a tree node <network> in Phihong Midspan devices, which allows the network

administrator to change the settings of dhcpStatus, ipAddr, ipmask, defaultGetway, primaryDNS

and secondaryDNS. If these settings are changed; the OID <saveNewSettings> must be set at a

value of “0” to reboot the device and validate the new settings. For other events requiring a system

reboot, users can also set a value of ‘0’ to <saveNetSettings>, except for a TFTP upload (refer to

Chapter 5: Firmware updating at ﬁeld). A TFTP upload requires a value greater than or equal to ‘6’

to validate the upload.

3. Although <hostname> should technically be listed under network, we place it into the <control>

section as it does not need a second step (rebooting) to be validated. <macAddr> which is read-

only and follows the same rebooting rule, is also in this section.

POE576U-4MP-N-R 数据表(PDF) 32 Page - Phihong USA Inc.