AOZ8000

Rev. 2.4 July 2010

www.aosmd.com

Page 13 of 15

Notes:

1. Dimensioning and tolerances conform to ASME Y14.5M-1994.

2. All dimensions are in millimeters. All angles are in degrees.

3. The terminal #1 identifier and terminal numbering convention shall conform to JESD 95-1 SPP-012. Details of terminal #1

are optional, but must be located within the zone indicated. The terminal #1 identifier may be a molded, marked, or metalized

feature.

4. Dimension b apply to metallized terminal and is measured between 0.15mm and 0.20mm from terminal tip.

5. Coplanarity applies to the exposed heat sink slug as well as the terminal.

6. Profile tolerance (aaa) will be applicable only to the plastic body, and not to the metallized fetures (such as terminal tips and tie bars.)

Metallized features may protrude a maximum of L2 from the plastic body profile.

7. Corners will be sharp unless otherwise specified with radius dimensions.

8. This feature applies to both ends of the package.

9. If L1 max. is not called out, the metalized feature will extend to the exposed pad. Thus, the 0.17mm gap does not apply.

Symbols

A

A1

A2

A3

b

D

E

e

E4

E2

D4

D2

L

L1

L2

R

R1

R2

aaa

bbb

ccc

ddd

eee

θ

Dimensions in millimeters

Min.

0.80

0.00

0.65

0.15

0.18

0.56

0.84

0.21

0.52

0.20

—

0

°

Nom.

0.90

0.025

0.70

0.20

0.20

2.0 BSC

2.0 BSC

0.65 BSC

0.66

0.94

0.31

0.62

0.29

—

—

0.075 REF

0.075 REF

—

0.10

0.10

0.10

0.05

0.08

10

°

Max.

1.00

0.05

0.75

0.25

0.28

0.76

1.04

0.41

0.72

0.45

0.125

12

°

Symbols

A

A1

A2

A3

b

D

E

e

E4

E2

D4

D2

L

L1

L2

R

R1

R2

aaa

bbb

ccc

ddd

eee

θ

Min.

0.031

0.000

0.026

0.006

0.007

0.022

0.033

0.008

0.020

0.008

—

0

°

Nom.

0.035

0.001

0.028

0.008

0.008

0.079 BSC

0.079 BSC

0.026 BSC

0.026

0.037

0.012

0.024

0.011

—

—

0.003 REF

0.003 REF

—

0.004

0.004

0.004

0.002

0.003

10

°

Max.

0.039

0.002

0.030

0.010

0.011

0.030

0.041

0.016

0.028

0.018

0.005

12

°

Dimensions in inches