ADT7320

Data Sheet

Rev. 0 | Page 12 of 24

TEMPERATURE DATA FORMAT

One LSB of the ADC corresponds to 0.0625°C in 13-bit mode or

0.0078°C in 16-bit mode. The ADC can theoretically measure a

temperature range of 255°C, but the ADT7320 is guaranteed to

measure a low value temperature limit of −40°C to a high value

temperature limit of +150°C. The temperature measurement

result is stored in the 16-bit temperature value register and is

setpoint register are represented by a 13-bit, twos complement

word. The MSB is the temperature sign bit. On power-up the three

LSBs, Bit 0 to Bit 2, are not part of the temperature conversion

the 13-bit temperature data format without Bit 0 to Bit 2.

The number of bits in the temperature data-word can be extended

to 16 bits, twos complement by setting Bit 7 to 1 in the configuration

register (Register Address 0x01). When using a 16-bit temperature

data value, Bit 0 to Bit 2 are not used as flag bits and are instead

the LSB bits of the temperature value. The power-on default

setting has a 13-bit temperature data value.

Reading back the temperature from the temperature value register

requires a 2-byte read. Designers that use a 9-bit temperature

data format can still use the ADT7320 by ignoring the last four

LSBs of the 13-bit temperature value. These four LSBs are Bit 3

to Bit 6 in Table 5.

Table 5. 13-Bit Temperature Data Format

Temperature

Digital Output (Binary) Bits[15:3]

−40°C

1 1101 1000 0000

−25°C

1 1110 0111 0000

−0.0625°C

1 1111 1111 1111

0°C

0 0000 0000 0000

+0.0625°C

0 0000 0000 0001

+25°C

0 0001 1001 0000

+105°C

0 0110 1001 0000

+125°C

0 0111 1101 0000

+150°C

0 1001 0110 0000

TEMPERATURE CONVERSION FORMULAS

16-Bit Temperature Data Format

Positive Temperature = ADC Code (dec)/128

Negative Temperature = (ADC Code (dec) − 65,536)/128

where ADC Code uses all 16 bits of the data byte, including the

sign bit.

Negative Temperature = (ADC Code (dec) − 32,768)/128

where the MSB is removed from the ADC code.

13-Bit Temperature Data Format

Positive Temperature = ADC Code (dec)/16

Negative Temperature = (ADC Code (dec) − 8192)/16

where ADC Code uses all 13 bits of the data byte, including the

sign bit.

Negative Temperature = (ADC Code (dec) − 4096)/16

where the MSB is removed from the ADC code.

10-Bit Temperature Data Format

Positive Temperature = ADC Code (dec)/2

Negative Temperature = (ADC Code (dec) − 1024)/2

where ADC Code uses all 10 bits of the data byte, including the

sign bit.

Negative Temperature = (ADC Code (dec) − 512)/2

where the MSB is removed from the ADC Code.

9-Bit Temperature Data Format

Positive Temperature = ADC Code (dec)

Negative Temperature = ADC Code (dec) − 512

where ADC Code uses all nine bits of the data byte, including

the sign bit.

Negative Temperature = ADC Code (dec) − 256

where the MSB is removed from the ADC Code.