TLC272CPWR datasheet(32/51 Pages) TI

32 / 51 page

TLC272, TLC272A, TLC272B, TLC272Y, TLC277

LinCMOS

 PRECISION DUAL OPERATIONAL AMPLIFIERS

SLOS091E – OCTOBER 1987 – REVISED FEBRUARY 2002

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

APPLICATION INFORMATION

output characteristics (continued)

Figure 42. Resistive Pullup to Increase VOH

VDD – VO

IF + IL + IP

Rp =

VDD

–

Ip = Pullup current required by

the operational amplifier

(typically 500

µA)

Figure 43. Compensation for Input Capacitance

feedback

Operational amplifier circuits almost always employ feedback, and since feedback is the first prerequisite for

oscillation, some caution is appropriate. Most oscillation problems result from driving capacitive loads

(discussed previously) and ignoring stray input capacitance. A small-value capacitor connected in parallel with

the feedback resistor is an effective remedy (see Figure 43). The value of this capacitor is optimized empirically.

electrostatic discharge protection

The TLC272 and TLC277 incorporate an internal electrostatic discharge (ESD) protection circuit that prevents

functional failures at voltages up to 2000 V as tested under MIL-STD-883C, Method 3015.2. Care should be

exercised, however, when handling these devices as exposure to ESD may result in the degradation of the

device parametric performance. The protection circuit also causes the input bias currents to be temperature

dependent and have the characteristics of a reverse-biased diode.

latch-up

Because CMOS devices are susceptible to latch-up due to their inherent parasitic thyristors, the TLC272 and

TLC277 inputs and outputs were designed to withstand –100-mA surge currents without sustaining latch-up;

however, techniques should be used to reduce the chance of latch-up whenever possible. Internal protection

diodes should not, by design, be forward biased. Applied input and output voltage should not exceed the supply

voltage by more than 300 mV. Care should be exercised when using capacitive coupling on pulse generators.

Supply transients should be shunted by the use of decoupling capacitors (0.1

µF typical) located across the

supply rails as close to the device as possible.

The current path established if latch-up occurs is usually between the positive supply rail and ground and can

be triggered by surges on the supply lines and/or voltages on either the output or inputs that exceed the supply

voltage. Once latch-up occurs, the current flow is limited only by the impedance of the power supply and the

forward resistance of the parasitic thyristor and usually results in the destruction of the device. The chance of

latch-up occurring increases with increasing temperature and supply voltages.

TLC272CPWR 数据表(PDF) 32 Page - Texas Instruments

TLC272CPWR 数据表(HTML) 32 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

数据表下载