LPC2104FBD48 datasheet(21/41 Pages) NXP

21 / 41 page

LPC2104_2105_2106_7

Product data sheet

Rev. 07 — 20 June 2008

21 of 41

NXP Semiconductors

LPC2104/2105/2106

Single-chip 32-bit microcontrollers

With double edge controlled PWM outputs, speciﬁc match registers control the rising and

falling edge of the output. This allows both positive going PWM pulses (when the rising

edge occurs prior to the falling edge), and negative going PWM pulses (when the falling

edge occurs prior to the rising edge).

6.17.1 Features

• Seven match registers allow up to six single edge controlled or three double edge

controlled PWM outputs, or a mix of both types.

• The match registers also allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Supports single edge controlled and/or double edge controlled PWM outputs. Single

edge controlled PWM outputs all go HIGH at the beginning of each cycle unless the

output is a constant LOW. Double edge controlled PWM outputs can have either edge

occur at any position within a cycle. This allows for both positive going and negative

going pulses.

• Pulse period and width can be any number of timer counts. This allows complete

ﬂexibility in the trade-off between resolution and repetition rate. All PWM outputs will

occur at the same repetition rate.

• Double edge controlled PWM outputs can be programmed to be either positive going

or negative going pulses.

• Match register updates are synchronized with pulse outputs to prevent generation of

erroneous pulses. Software must “release” new match values before they can become

effective.

• May be used as a standard timer if the PWM mode is not enabled.

• A 32-bit Timer/Counter with a programmable 32-bit Prescaler.

6.18 System control

6.18.1 Crystal oscillator

The oscillator supports crystals in the range of 1 MHz to 25 MHz. The oscillator output

frequency is called FOSC and the ARM processor clock frequency is referred to as CCLK

for purposes of rate equations, etc. FOSC and CCLK are the same value unless the PLL

is running and connected. Refer to Section 6.18.2 “PLL” for additional information.

6.18.2 PLL

The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input

frequency is multiplied up into the range of 10 MHz to 60 MHz with a Current Controlled

Oscillator (CCO). The multiplier can be an integer value from 1 to 32 (in practice, the

multiplier value cannot be higher than 6 on this family of microcontrollers due to the upper

frequency limit of the CPU). The CCO operates in the range of 156 MHz to 320 MHz, so

there is an additional divider in the loop to keep the CCO within its frequency range while

the PLL is providing the desired output frequency. The output divider may be set to divide

LPC2104FBD48 数据表(PDF) 21 Page - NXP Semiconductors

LPC2104FBD48 数据表(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

数据表下载