| 数据搜索系统,热门电子元器件搜索 |
|
PM6652 数据表(PDF) 38 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
PM6652 数据表(HTML) 38 Page - STMicroelectronics |
|
38 / 53 page ![]() Device description PM6652 38/53 Doc ID 16867 Rev 5 the external MOSFET or the inductor, allows the controller to monitor the thermal status of the power components (see Figure 40). In applications where this function is not required (in render core supply, for example) the THERM pin must be connected to 5 V and VRTT# can be left floating. Figure 40. Voltage regulator thermal throttling 8.10.4 Overvoltage protection The PM6652 can detect two kinds of VOUT overvoltage: ● Fixed 1.55 V overvoltage threshold ● Variable +200 mV overvoltage threshold, referred to VDAC reference voltage. Both overvoltage protections are latched, so a COREON or SVCC toggle is required in order to restart the device. If the fixed overvoltage threshold is reached, the high-side MOSFET is immediately turned off and the output capacitor is sharply discharged by turning on the low-side MOSFET. This fault protection is always active. When a variable VOUT overvoltage is detected, both high-side and low-side external MOSFETs are turned off and the output capacitor soft-discharge is performed. The internal discharge MOSFET is turned on until VOUT is lower than about 100 mV, then the low-side MOSFET is turned on (see Figure 20 on page 22). This fault detection is masked during VID transitions and, during soft-start, until the power good signal is released. 8.10.5 Undervoltage protection If the switching voltage regulator output falls below -300 mV, referred to VDAC programmed voltage, the latched undervoltage fault is detected and the output capacitor soft-discharge is performed. The internal discharge MOSFET is turned on until VCC_GFX is lower than about 100 mV, then the low-side MOSFET is turned on (see Figure 21). This fault detection is masked during VID transitions and, during soft-start, until the power good signal is released. The undervoltage protection can't be detected if the programmed VDAC voltage is lower than 300 mV. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |