AS5030 datasheet(22/44 Pages) AMSCO

22 / 44 page

www.ams.com/AS5030

Revision 2.4

22 - 44

AS5030

Datasheet - Application In formatio n

8 Application Information

AS5030 Parameter and Features List.

Parameter

Description

Supply voltage

5V ± 10%

Supply current

Low Power Mode, non-operational: typ. 1.4mA

Ultra-low Power Mode, non-operational: typ. 30µA

Normal operating mode: typ. 14mA.

Absolute output; Serial Interface

21-bit Synchronous Serial Interface (SSI): 5 command bits, 2 data valid bits, 6 data bits for magnetic

field strength, 8 data bits for angle.

Configurable for 2-wire (Clock, Data) or 3-wire (Chip Select, Clock, Data) operation

Daisy Chain mode for reading multiple encoders through a 2- or 3-wire interface.

Zero Position Programming (OTP)

SSI clock rate

≤ 6 MHz data clock rate, 250 ~ 500kHz during programming

2-wire readout mode

DIO and CLK signals. 0.1 ~ 6MHz clock rate. Synchronization through time-out of CLK signal.

Power down modes

Activated and deactivated by software commands.

Low Power Mode: power down current = 1.4mA typ.; power up time <150µs

Ultra-low Power Mode: power down current = 30µA typ.; power up time <500µs

Digital input cells

CLK, CS = Schmitt trigger inputs

SIN-COS mode

Sine, inverse Sine, Cosine and inverse Cosine outputs. 360° per period.

Maximum speed

30.000 rpm with locked ADC

Resolution and accuracy

Resolution = 8-bit (1.406°)

Accuracy

≤ ± 2° with centered magnet

Transition noise

0.24°rms (1 sigma)

PWM output

2.26µs / Step, PWM will be permanently low when angular data is not valid (e.g. during startup).

Digital output current

4mA @ VDD = 5V (PWM, DIO, DX, MagRngn outputs)

OTP programming mode

Through serial interface with static programming voltage on pin #2 (PROG)

16-bit OTP programming register. OTP user programming options:

Angular zero position: 8 bit

Hall element sensitivity: 2 bit

Magnetic field range

Trimmable in four steps with OTP programming (sensitivity)

maximum/minimum ratio ~ 2.5:1. Field range window = 20 ~ 80mT

(e.g. maximum sensitivity range = 20 ~ 48mT, minimum sensitivity range = 32 ~ 80mT

Non-valid-range indication

By hardware: MagRngn pin indicates locked condition of ADC

By software: LOCK1&2 status bits indicate locked condition of ADC

Start-up timings

Start-up time after shutdown < 2ms

Start-up time after power-down from Ultra-low Power Mode: < 500µs

Start-up time after power-down from Low Power Mode: < 150µs

ESD protection

± 2kV

Operating temperature

-40°C ~ +125°C

AS5030 数据表(PDF) 22 Page - ams AG

AS5030 数据表(HTML) 22 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载