EM357 Mini Modules

Page 14

This document is subject to change without notice

Document No: 0011-00-07-00-000 (Issue H)

IC Certification — Industry Canada Statement

The term "IC" before the certification/registration number only signifies that the Industry Canada technical

specifications were met.

Certification IC — Déclaration d'Industrie Canada

Leterme"IC"devantlenumérodecertification/d'enregistrementsignifieseulementquelesspécificationstechniques

Industrie Canada ont été respectées.

Section 14 of RSS-210

The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit

RF field in excess of Health Canada limits for the general population. Consult Safety Code 6, obtainable from

Health Canada's website: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php

L'article 14 du CNR-210

Le programme d'installation de cet équipement radio doit s'assurer que l'antenne est située ou

orientée de telle sorte qu'il ne pas émettre de champ RF au-delà des limites de Santé Canada pour

la population générale. Consulter le Code de sécurité 6, disponible sur le site Web de Santé Canada:

http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php

CE Certification — Europe

The MeshConnect ZICM35xSP0 Module has been tested and certified for use in the European Union.

OEM Responsibility to the European Union Compliance Rules

If the MeshConnect Module is to be incorporated into a product, the OEM must verify compliance of the final

product to the European Harmonized EMC and Low-Voltage/Safety Standards. A Declaration of Conformity must

be issued for each of these standards and kept on file as described in Annex II of the R&TTE Directive.

The manufacturer must maintain the user guide and adhere to the settings described in the manual for maintaining

European Union Compliance. If any of the specifications are exceeded in the final product, the OEM is required to

make a submission to the notified body for compliance testing.

OEM Labeling Requirements

The CE mark must be placed on the OEM product in a visible location. The CE mark shall consist of the initials

CE with the following form:

· If the CE marking is reduced or enlarged, the proportions given in the CE

graduated drawing (to the right) must be adhered to

· The CE mark must be a minimum of 5mm in height

· If the use of the module is subject to restrictions in the end application, the CE

marking on the OEM product should also include the alert sign as shown in the

image to the right