Set of 6 front panel LEDs display continuous status information

Set of 4 dip switches support AC input selection of 230V, selectable 50 /60Hz frequency, and selectable full or half cycle transfer times

Set of 4 dip switches support wet/gel battery charging profiles, adjustable 260/270V (230V) high voltage auto transfer during overvoltages and selectable

150/60V / 170/180V (230V) AC low voltage auto transfer during brownouts

Set of 4 additional dip switches support battery equalization program and battery charger low / high settings

Automatic overload and thermal (overheating) shutoff

Front panel remote control connector enables remote off/on switching (APSRM4 sold separately)

Load sensing control dial enables adjustable load threshold required to automatically turn the inverter on and off in DC mode as load conditions change

Automatic Generator Starter jack enables user configuration of automatic generator start-up as inverter batteries drop to 23.0 VDC and generator shutoff

as inverter batteries are recharged to 28.2 VDC.

Remote battery temperature sensing connection function prolongs battery life by adjusting the charge float voltage level based on battery temperature

DB9 communication port for SNMPWEBSOLOHV management.

Specifications

OUTPUT

Frequency Compatibility

50 / 60 Hz

Output Receptacles

Hardwire

Output (Watts)

6000

Continuous Output Capacity (Watts)

6000

Peak Output Capacity (Watts)

12000

Output Nominal Voltage

208/230V

Output Voltage Regulation

LINE POWER (AC): Maintains 208/230V nominal sine wave output from line power source. INVERTER POWER

(AC): Maintains sine wave output voltage of 208/230 VAC (+/-5%).

Output Frequency Regulation

50/60 Hz (+/- 0.3 Hz)

Pure Sine Wave Output

No

INPUT

Nominal Input Voltage(s) Supported

208V AC; 230V AC

Recommended Electrical Service

DC INPUT: Requires 48VDC input source capable of delivering 138A for the required duration (when used at full

continuous capacity - DC requirements increase during OverPower and DoubleBoost operation). For automotive

applications, professional hardwire installation with 250A minimum battery system fusing is recommended.

Maximum Input Amps / Watts

DC INPUT: Full continuous load - 145A at 48VDC. AC INPUT: 30 amps at 208/230VAC with full inverter and charger

load

Input Connection Type

DC INPUT: Set of DC bolt-down terminals. AC INPUT: Hardwire via built in terminal strip with cover plate

Voltage Compatibility (VAC)

208; 230

Voltage Compatibility (VDC)

48

BATTERY

Expandable Battery Runtime

Runtime is expandable with any number of user supplied wet or gel type batteries

2 / 4