MIS2DH datasheet(23/49 Pages) STMICROELECTRONICS

23 / 49 page

DocID027506 Rev 2

23/49

MIS2DH

Digital interfaces

The registers embedded inside the MIS2DH may be accessed through both the I2C and SPI

serial interfaces. The latter may be SW configured to operate either in 3-wire or 4-wire

interface mode.

The serial interfaces are mapped to the same pads. To select/exploit the I2C interface, the

CS line must be tied high (i.e. connected to Vdd_IO).

5.1

I2C serial interface

The MIS2DH I2C is a bus slave. The I2C is employed to write data into registers whose

content can also be read back.

The relevant I2C terminology is given in the table below.

There are two signals associated with the I2C bus: the serial clock line (SCL) and the serial

data line (SDA). The latter is a bidirectional line used for sending and receiving data to/from

the interface. Both the lines must be connected to Vdd_IO through an external pull-up

resistor. When the bus is free, both the lines are high.

The I2C interface is compliant with fast mode (400 kHz) I2C standards as well as with the

normal mode.

Table 12. Serial interface pin description

Pin name

Pin description

SPI enable

I2C/SPI mode selection:

1: SPI idle mode / I2C communication enabled

0: SPI communication mode / I2C disabled

SCL

SPC

I2C serial clock (SCL)

SPI serial port clock (SPC)

SDA

SDI

SDO

I2C serial data (SDA)

SPI serial data input (SDI)

3-wire interface serial data output (SDO)

SA0

SDO

I2C less significant bit of the device address (SA0)

SPI serial data output (SDO)

Table 13. I2C terminology

Term

Description

Transmitter

The device which sends data to the bus

Receiver

The device which receives data from the bus

Master

The device which initiates a transfer, generates clock signals and terminates a

transfer

Slave

The device addressed by the master

MIS2DH 数据表(PDF) 23 Page - STMicroelectronics

MIS2DH 数据表(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载