STWBC datasheet(16/36 Pages) STMICROELECTRONICS

16 / 36 page

Electrical characteristics

STWBC

16/36

DocID027322 Rev 3

Table 3. Current characteristics

Symbol

Ratings

Max.(1)

1. Data based on characterization results, not tested in production

Unit

IVDDX

Total current into VDDX power lines(2)

2. All power VDDX (VDD, VDDA) and ground VSSX (VSS, VSSA) pins must always be connected to the external

power supply.

100

IVSSX

Total current out of VSSX power lines(2)

100

IIO

Output current sunk by any I/Os and control pin

Ref. to Table 11

on page 21

Output current source by any I/Os and control pin

IINJ(PIN)(3), (4)

3. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS.

4. Negative injection disturbs the analog performance of the device.

Injected current on any pin

±4

IINJ(TOT)(3), (4), (5)

5. When several inputs are submitted to a current injection, the maximum

IINJ(PIN) is the absolute sum of the

positive and negative injected currents (instantaneous values). These results are based on

characterization with

IINJ(PIN) maximum current injection on four I/O port pins of the device.

Sum of injected currents

±20

Table 4. Thermal characteristics

Symbol

Ratings

Max.

Unit

TSTG

Storage temperature range

-65 to 150

ºC

Maximum junction temperature

150

STWBC 数据表(PDF) 16 Page - STMicroelectronics

STWBC 数据表(HTML) 16 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载