The following specifications apply for V

all other limits T

Symbol

Parameter

Conditions

Typical

Limits

Units

(Limit)

(Note 7)

(Note 8)

V

IL

Logic “0” Input Voltage

V

Mode Pin

1.5

V (max)

ADC08062

CS, WR, RD, A0 Pins

0.7

V (max)

ADC08061

CS, WR, RD Pins

0.8

V (max)

I

IH

Logic “1” Input Current

V

CS, RD, A0 Pins

0.005

1

µA (max)

WR Pin

0.1

3

µA (max)

Mode Pin

50

200

µA (max)

I

IL

Logic “0” Input Current

V

CS, RD, WR, A0 Pins

−0.005

µA (max)

Mode Pin

−2

V

OH

Logic “1” Output Voltage

V

I

DB0–DB7, OFL, INT

2.4

V (min)

I

DB0–DB7, OFL, INT

4.5

V (min)

V

OL

Logic “0” Output Voltage

V

I

0.4

V (max)

DB0–DB7, OFL, INT, RDY

I

O

TRI-STATE Output Current

V

0.1

3

µA (max)

DB0–DB7, RDY

V

−0.1

−3

µA (max)

DB0–DB7, RDY

I

SOURCE

Output Source Current

V

−26

−6

mA (min)

DB0–DB7, OFL, INT

I

SINK

Output Sink Current

V

24

7

mA (min)

DB0–DB7, OFL, INT, RDY

I

C

Supply Current

CS = WR = RD = 0

11.5

20

mA (max)

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. DC and AC electrical specifications do not apply when operating

the device beyond its specified operating ratings. Operating Ratings indicate conditions for which the device is functional, but do not guarantee performance limits.

For guaranteed specifications and test conditions, see the Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed. Some per-

formance characteristics may degrade when the device is not operated under the listed test conditions.

Note 2: All voltages are measured with respect to the GND pin, unless otherwise specified.

limited to 5 mA or less. The 20 mA package input current specification limits the number of pins that can exceed the power supply boundaries witha5mA current

limit to four.

Note 4: The power dissipation of this device under normal operation should never exceed 875 mW (Quiescent Power Dissipation + the loads on the digital outputs).

Caution should be taken not to exceed absolute maximum power rating when the device is operating in a severe fault condition (e.g., when any input or output ex-

of the ADC08061/2.

Part Number

θ

JA

ADC08061/2BIN

105

51

ADC08061/2CIWM

105

85

Note 5: See AN-450 “Surface Mounting Methods and Their Effect on Product Reliability” for other methods of soldering surface mount devices.

Note 6: Human body model, 100 pF discharged through a 1.5 k

Ω resistor.

Note 7: Typicals are at 25˚C and represent most likely parametric norm.

www.national.com

6