EM78P447SAP datasheet(24/55 Pages) EMC

24 / 55 page

EM78P447S

OTP ROM

4.7 Oscillator

1. Oscillator Modes

The EM78P447S can operate in three different oscillator modes, i.e., high XTAL (HXT) oscillator mode, low XTAL (LXT)

oscillator mode, and External RC oscillator mode (ERC) oscillator mode. User can select one of them by programming MS,

HLF and HLP in the Code Option Register. Table 7 depicts how these three modes are defined.

The maximum limit for operational frequencies of crystal/resonator under different VDDs is listed in Table 8.

Table 8 Oscillator Modes Defined by MS and HLP

Mode

HLF

HLP

ERC(External RC oscillator mode)

HXT(High XTAL oscillator mode)

LXT(Low XTAL oscillator mode)

<Note>

1. X, Don’t care

2. The transient point of system frequency between HXT and LXY is around 400 KHz.

Table 9 The Summary of Maximum Operating Speeds

Conditions

VDD

Fxt max.(MHz)

2.3

4.0

3.0

8.0

Two cycles with two clocks

5.0

20.0

2. Crystal Oscillator/Ceramic Resonators(XTAL)

EM78P447S can be driven by an external clock signal through the OSCI pin as shown in Fig. 10 below.

In most applications, Pin OSCI and Pin OSCO can be connected with a crystal or ceramic resonator to generate

oscillation. Fig. 11 depicts such circuit. The same thing applies whether it is in the HXT mode or in the LXT mode. Table 9

provides the recommended values of C1 and C2. Since each resonator has its own attribute, user should refer to its

specification for appropriate values of C1 and C2. RS. A serial resistor may be necessary for AT strip cut crystal or low

frequency mode.

This specification is subject to change without prior notice.

06.25.2003 (V1.1)

EM78P447SAP 数据表(PDF) 24 Page - ELAN Microelectronics Corp

EM78P447SAP 数据表(HTML) 24 Page - ELAN Microelectronics Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

数据表下载