P89LPC922FN datasheet(22/45 Pages) PHILIPS

22 / 45 page

Philips Semiconductors

P89LPC920/921/922

8-bit microcontrollers with two-clock 80C51 core

Product data

Rev. 06 — 21 November 2003

22 of 45

9397 750 12285

Remark: During a power cycle, VDD must fall below VPOR (see Table 8 “DC electrical

characteristics” on page 35) before power is reapplied, in order to ensure a power-on

reset.

Reset can be triggered from the following sources:

• External reset pin (during power-up or if user conﬁgured via UCFG1);

• Power-on detect;

• Brownout detect;

• Watchdog Timer;

• Software reset;

• UART break character detect reset.

For every reset source, there is a ﬂag in the Reset Register, RSTSRC. The user can

read this register to determine the most recent reset source. These ﬂag bits can be

cleared in software by writing a ‘0’ to the corresponding bit. More than one ﬂag bit

may be set:

• During a power-on reset, both POF and BOF are set but the other ﬂag bits are

cleared.

• For any other reset, previously set ﬂag bits that have not been cleared will remain

set.

8.15.1

Reset vector

Following reset, the P89LPC920/921/922 will fetch instructions from either address

0000h or the Boot address. The Boot address is formed by using the Boot Vector as

the high byte of the address and the low byte of the address = 00h.

The Boot address will be used if a UART break reset occurs, or the non-volatile Boot

Status bit (BOOTSTAT.0) = 1, or the device is forced into ISP mode during power-on

(see

P89LPC920/921/922 User’s Manual). Otherwise, instructions will be fetched

from address 0000H.

8.16 Timers/counters 0 and 1

The P89LPC920/921/922 has two general purpose counter/timers which are upward

compatible with the standard 80C51 Timer 0 and Timer 1. Both can be conﬁgured to

operate either as timers or event counter. An option to automatically toggle the T0

and/or T1 pins upon timer overﬂow has been added.

In the ‘Timer’ function, the register is incremented every machine cycle.

In the ‘Counter’ function, the register is incremented in response to a 1-to-0 transition

at its corresponding external input pin, T0 or T1. In this function, the external input is

sampled once during every machine cycle.

Timer 0 and Timer 1 have ﬁve operating modes (modes 0, 1, 2, 3 and 6). Modes 0, 1,

2 and 6 are the same for both Timers/Counters. Mode 3 is different.

P89LPC922FN 数据表(PDF) 22 Page - NXP Semiconductors

P89LPC922FN 数据表(HTML) 22 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

数据表下载