TLC080IP datasheet(17/53 Pages) TI1

17 / 53 page

600 Ω

22 pF

50 Ω

10 kΩ

10 pF

With

CF = 10 pF

VDD = ±5 V

AV = +1

RF = 10 kΩ

RL = 600 Ω

CL = 22 pF

0.5

1.5

0.2 0.4 0.6 0.8

1.2 1.4 1.6

t - Time - ms

VIN

VOUT

0.5

TLC080 , TLC081, TLC082

TLC083, TLC084, TLC085, TLC08xA

www.ti.com

SLOS254F

– JUNE 1999 – REVISED DECEMBER 2011

High Speed CMOS Input Amplifiers

The TLC08x is a family of high-speed low-noise CMOS input operational amplifiers that has an input capacitance

of the order of 20 pF. Any resistor used in the feedback path adds a pole in the transfer function equivalent to the

input capacitance multiplied by the combination of source resistance and feedback resistance. For example, a

gain of

–10, a source resistance of 1 kΩ, and a feedback resistance of 10 kΩ add an additional pole at

approximately 8 MHz. This is more apparent with CMOS amplifiers than bipolar amplifiers due to their greater

input capacitance.

This is of little consequence on slower CMOS amplifiers, as this pole normally occurs at frequencies above their

unity-gain bandwidth. However, the TLC08x with its 10-MHz bandwidth means that this pole normally occurs at

frequencies where there is on the order of 5dB gain left and the phase shift adds considerably.

The effect of this pole is the strongest with large feedback resistances at small closed loop gains. As the

feedback resistance is increased, the gain peaking increases at a lower frequency and the 180

° phase shift

crossover point also moves down in frequency, decreasing the phase margin.

For the TLC08x, the maximum feedback resistor recommended is 5 k

Ω; larger resistances can be used but a

capacitor in parallel with the feedback resistor is recommended to counter the effects of the input capacitance

pole.

The TLC083 with a 1-V step response has an 80% overshoot with a natural frequency of 3.5 MHz when

configured as a unity gain buffer and with a 10-k

Ω feedback resistor. By adding a 10-pF capacitor in parallel with

the feedback resistor, the overshoot is reduced to 40% and eliminates the natural frequency, resulting in a much

faster settling time (see Figure 49). The 10-pF capacitor was chosen for convenience only.

Load capacitance had little effect on these measurements due to the excellent output drive capability of the

TLC08x.

Figure 49. 1-V Step Response

Submit Documentation Feedback

Product Folder Link(s): TLC080 TLC081 TLC082 TLC083 TLC084 TLC085 TLC08xA

TLC080IP 数据表(PDF) 17 Page - Texas Instruments

TLC080IP 数据表(HTML) 17 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

数据表下载