ADR6

Bit7

ADR5

bit6

ADR4

bit5

ADR3

bit4

ADR2

bit3

ADR1

bit2

ADR0

bit1

R/W

bit0

MSB

LSB

x

x

x

I

2

C SLAVE address (chip address)

x

x

x

x

SDA

SCL

Start

Condition

Stop

Condition

S

P

LP8550

www.ti.com

SNVS657E – SEPTEMBER 2010 – REVISED SEPTEMBER 2014

Programming (continued)

Figure 22. Start and Stop Conditions

In addition to the first Start Condition, a repeated Start Condition can be generated in the middle of a transaction.

This allows another device to be accessed, or a register read cycle.

8.5.1.3 Acknowledge Cycle

The Acknowledge Cycle consists of two signals: the acknowledge clock pulse the master sends with each byte

transferred, and the acknowledge signal sent by the receiving device.

The master generates the acknowledge clock pulse on the ninth clock pulse of the byte transfer. The transmitter

releases the SDA line (permits it to go high) to allow the receiver to send the acknowledge signal. The receiver

must pull down the SDA line during the acknowledge clock pulse and ensure that SDA remains low during the

high period of the clock pulse, thus signaling the correct reception of the last data byte and its readiness to

receive the next byte.

8.5.1.4 “Acknowledge After Every Byte” Rule

The master generates an acknowledge clock pulse after each byte transfer. The receiver sends an acknowledge

signal after every byte received.

There is one exception to the “acknowledge after every byte” rule. When the master is the receiver, it must

indicate to the transmitter an end of data by not-acknowledging (“negative acknowledge”) the last byte clocked

out of the slave. This “negative acknowledge” still includes the acknowledge clock pulse (generated by the

master), but the SDA line is not pulled down.

8.5.1.5 Addressing Transfer Formats

Each device on the bus has a unique slave address. The LP8550 operates as a slave device with 7-bit address

combined with data direction bit. Slave address is 2Ch as 7-bit or 58h for write and 59h for read in 8-bit format.

Before any data is transmitted, the master transmits the address of the slave being addressed. The slave device

should send an acknowledge signal on the SDA line, once it recognizes its address.

The slave address is the first seven bits after a Start Condition. The direction of the data transfer (R/W) depends

on the bit sent after the slave address — the eighth bit.

When the slave address is sent, each device in the system compares this slave address with its own. If there is a

match, the device considers itself addressed and sends an acknowledge signal. Depending upon the state of the

R/W bit (1:read, 0:write), the device acts as a transmitter or a receiver.

Copyright © 2010–2014, Texas Instruments Incorporated

Submit Documentation Feedback

23

Product Folder Links: LP8550