LM63 datasheet(12/28 Pages) NSC

12 / 28 page

1.0 Functional Description (Continued)

1.10 FAULT QUEUE

The LM63 incorporates a Fault Queue to suppress errone-

ous ALERT triggering . The Fault Queue prevents false

triggering by requiring three consecutive out-of-limit HIGH,

LOW, or T_CRIT temperature readings. See Figure 9. The

Fault Queue defaults to OFF upon power-up and may be

activated by setting the RDTS Fault Queue bit in the Con-

figuration Register to a 1.

1.11 ONE-SHOT REGISTER

The One-Shot Register is used to initiate a single conversion

and comparison cycle when the device is in standby mode,

after which the data returns to standby. This is not a data

The data written to this address is irrelevant and is not

stored. A zero will always be read from this register.

1.12 SERIAL INTERFACE RESET

In the event that the SMBus Master is reset while the LM63

is transmitting on the SMBDAT line, the LM63 must be

returned to a known state in the communication protocol.

This may be done in one of two ways:

When SMBDAT is Low, the LM63 SMBus state machine

resets to the SMBus idle state if either SMBData or

SMBCLK are held Low for more than 35 ms (t

TIMEOUT).

All devices are to timeout when either the SMBCLK or

SMBDAT lines are held Low for 25 ms – 35 ms. There-

fore, to insure a timeout of all devices on the bus, either

the SMBCLK or the SMBData line must be held Low for

at least 35 ms.

With both SMBDAT and SMBCLK High, the master can

initiate an SMBus start condition with a High to Low

transition on the SMBDAT line. The LM63 will respond

properly to an SMBus start condition at any point during

the communication. After the start the LM63 will expect

an SMBus Address address byte.

20057013

FIGURE 9. Fault Queue Temperature Response

Diagram

LM63 数据表(PDF) 12 Page - National Semiconductor (TI)

LM63 数据表(HTML) 12 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载