STM32F412RG datasheet(124/193 Pages) STMICROELECTRONICS

124 / 193 page

Electrical characteristics

STM32F412xE/G

124/193

DocID028087 Rev 4

6.3.19

Communications interfaces

I2C interface characteristics

The I2C interface meets the requirements of the standard I2C communication protocol with

the following restrictions: the I/O pins SDA and SCL are mapped to are not “true” open-

drain. When configured as open-drain, the PMOS connected between the I/O pin and VDD is

disabled, but is still present.

The I2C characteristics are described in Table 61. Refer also to Section 6.3.16: I/O port

characteristics for more details on the input/output alternate function characteristics (SDA

and SCL).

The I2C bus interface supports standard mode (up to 100 kHz) and fast mode (up to 400

kHz). The I2C bus frequency can be increased up to 1 MHz. For more details about the

complete solution, contact your local ST sales representative.

Table 61. I2C characteristics

Symbol

Parameter

Standard mode

I2C(1)(2)

1. Guaranteed by design, not tested in production.

Fast mode I2C(1)(2)

2. fPCLK1 must be at least 2 MHz to achieve standard mode I2C frequencies. It must be at least 4 MHz to

achieve fast mode I2C frequencies, and a multiple of 10 MHz to reach the 400 kHz maximum I2C fast mode

clock.

Unit

Min

Max

Min

Max

tw(SCLL)

SCL clock low time

4.7

1.3

µs

tw(SCLH)

SCL clock high time

4.0

0.6

tsu(SDA)

SDA setup time

250

100

th(SDA)

SDA data hold time

3450(3)

3. The device must internally provide a hold time of at least 300 ns for the SDA signal in order to bridge the

undefined region of the falling edge of SCL.

0900(4)

tr(SDA)

tr(SCL)

SDA and SCL rise time

1000

300

tf(SDA)

tf(SCL)

SDA and SCL fall time

300

th(STA)

Start condition hold time

4.0

0.6

µs

tsu(STA)

Repeated Start condition

setup time

4.7

0.6

tsu(STO)

Stop condition setup time

4.0

0.6

µs

tw(STO:STA)

Stop to Start condition time

(bus free)

4.7

1.3

µs

tSP

Pulse width of the spikes

that are suppressed by the

analog filter for standard fast

mode

120(5)

Capacitive load for each bus

line

400

STM32F412RG 数据表(PDF) 124 Page - STMicroelectronics

STM32F412RG 数据表(HTML) 124 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载