USB5744SLASH2G datasheet(15/49 Pages) MICROCHIP

15 / 49 page

 2015-2016 Microchip Technology Inc.

DS00001855D-page 15

USB5744

3.3

Buffer Types

TABLE 3-9:

BUFFER TYPES

Buffer Type

Description

Input

Schmitt-triggered input

Output with 6 mA sink and 6 mA source

O12

Output with 12 mA sink and 12 mA source

OD12

Open-drain output with 12 mA sink

50 µA (typical) internal pull-up. Unless otherwise noted in the pin description, internal pull-

ups are always enabled.

Internal pull-up resistors prevent unconnected inputs from floating. Do not rely on internal

resistors to drive signals external to the device. When connected to a load that must be

pulled high, an external resistor must be added.

50 µA (typical) internal pull-down. Unless otherwise noted in the pin description, internal

pull-downs are always enabled.

Internal pull-down resistors prevent unconnected inputs from floating. Do not rely on internal

resistors to drive signals external to the device. When connected to a load that must be

pulled low, an external resistor must be added.

IO-U

Analog input/output as defined in USB specification

Analog input

ICLK

Crystal oscillator input pin

OCLK

Crystal oscillator output pin

Power pin

Note:

Refer to Section 9.5, "DC Specifications" for individual buffer DC electrical characteristics.

USB5744/2G 数据表(PDF) 15 Page - Microchip Technology

USB5744/2G 数据表(HTML) 15 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

数据表下载